User manual BEGLEC LED PINSPOT V1.0

[. . . ] This is normal and disappears after some minutes. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. [. . . ] Important: Never look directly into the light source!Don't use the effect in the presence of persons suffering from epilepsy. This product meets the requirements of the current European and national guidelines. conformity has been established and the relevant statements and documents have been deposited by the manufacturer. This device was designed to produce decorative effect lighting and is used in light show systems. Extremely compact but very powerful white LED projector Perfect replacement for traditional 30W Pin Spots with better results Based on 3W white LED technology: Very low power consumption High color temperature for impressive results No lamp replacements!Virtually no heat production Lightweight (no lamp transformers needed) Two exchangeable lenses: Beam angle 6°: perfect for mirror ball projection Beam angle 11°: perfect to light up objects and small table in discotheques Mains powered: 100 ~ 240Vac Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. This symbol means: indoor use only Hanging bracket with knobs on both sides 3. Heatsink, needed to cool the power supply and LED 4. Keep the projector vertically with the lens upward Remove the metal fixing ring (A) gently. Return the projector gently upside-down so the lens (B) falls in your hand. Turn the projector back in vertical position and insert the new lens Put the metal fixing ring (A) back in place. [. . . ] Switch off the unit, unplug the mains cable and wait until the unit has been cooled down. During inspection the following points should be checked: All screws used for installing the device and any of its parts should be tightly fastened and may not be corroded. Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. [. . . ]