User manual BEGLEC LED SPOT V1.4

[. . . ] electric shock or malfunction may result. If a foreign object enters the unit, immediately disconnect the mains power. Prevent use in dusty environments and clean the unit regularly. Inexperienced persons should not operate this device. [. . . ] If you sell the fixture, be sure to add this user manual. Check the contents: Check that the carton contains the following items: Operating instructions LED Projector (spot or wash type) Hanging bracket 2 Knobs to fasten the hanging bracket Base plate with nut Plastic cover to protect the LEDs 2. Hanging bracket with knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. Important: The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. electrical installation for 1 standalone unit: Just insert the mains cable. The unit starts working immediately in stand-alone mode Remark: You can connect a CA-8 remote controller to the unit if you want to have more control. refer to section "C" to learn how to do this. Electrical installation for two or more units in master/slave: Connect 2 to maximum 16 units together using good quality balanced microphone cables (like for example JB Systems ref. The unit that has no cable connected to its DMX-input will react as "master", the others are the slave units. Make sure that all units are connected to the mains. Remark: You can connect a CA-8 remote controller to the master unit if you want to have more control over the master/slave operation. You can also connect the LEDCON 01 remote controller, in this case all units will respond equally (all units have the same color) Electrical installation for two or more units in DMX-mode: The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to "daisy chain" your DMX controller and all the connected units with a good quality balanced cable (ex. To prevent strange behavior of the light effects, due to interferences, you must use a 90 to 40 terminator at the end of the chain. Never use Y-splitter cables, this simply won't work!Make sure that all units are connected to the mains. Each light effect in the chain needs to have its proper starting address so it knows which commands from the controller it has to decode. In the next section you will learn how to set the DMX addresses. How to set the DMX addresses: There are 2 ways to set the DMX-address of the units A. Setting individual DMX-addresses per projector: Make sure the DMX cables of all units are connected. [. . . ] Remember that each unit uses 4 DMX-channels as shown in the DMX chart below: Fixed to wall or ceiling Standalone 1unit: Just connect the unit to the mains and put on some music. The unit starts working automatically to the rhythm of the music. Remark: You can connect a CA-8 remote controller to the unit if you want to have more control. Two or more units in master/slave setup: Connect 2 to maximum 16 units together. [. . . ]