User manual BEGLEC LED STRING WHITE V1.0

[. . . ] maximum save ambient temperature is 40°C. Don't use this unit at higher ambient temperatures. Always unplug the unit when it is not used for a longer time. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. [. . . ] The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual. Check the contents: Check that the carton contains the following items: Operating instructions 1 controller "LS-WH-CONTROL" 3 strings "LS-WH-STRING" 1 fixing eye CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. Mains connector: check if the mains voltage is not higher than 230V / 50Hz 2. Rubber seal: used to seal the program selector (5) completely from any possible moisture. Program selector: used to select one of the 16 internal programs, see chapter how to use for more information. White LED-bulbs: contains white LEDs, you can add up to 1024pcs in one line (string)!Fixing eye: can be used to clamp or stretch the string from the ceiling down etc. NEVER disconnect any parts or make any change in the setup while the installation is connected to the mains: some parts could be seriously damaged!THE SIMPLE WAY If you only want to use the standard "plug & play" starter set, things are VERY simple: just build the elements from this "LS-WH-STARTER" starter kit together and connect the complete string to the mains. Installation finished: no need to look any further!THE SOPHISTICATED WAY Based on the basic "LS-WH-STARTER" set you can build a bigger system, just by adding the optionally available accessories. For each of these accessories we give a description with possible applications: LS-POWER-7A The controller of the "starter set" can control strings with up to 1024 LEDbulbs, however its internal power supply only supports up to 12 LED-bulbs. This means that you should add an extra power supply, as soon as you add extra strings. The LS-POWER-7A power supply can deliver power for up to 116 LED-bulbs. So every 116 LED-bulbs an extra LS-POWER-7A should be inserted in the line. The LS-POWER-7A contains a special POWER-T, used to "inject" the extra power into the line with strings. See the example below to learn how to insert the LS-POWER-7A: You can add one or more strings in one line until a maximum of 1024 LED-bulbs is reached. Of course you should add extra LS-POWER-7A power supplies and LS-BUFFER signal buffers where needed! LS-CURTAIN-2M An LS-CURTAIN-2M is a 2m long cable containing 8 T-connectors, used to create a nice LED-curtain. [. . . ] Always unplug the unit when it is not used for a longer time or before replacing the bulb or start servicing. In the event of serious operating problems, stop using the fixture and contact your dealer immediately. Important: Don't use the effect in the presence of persons suffering from epilepsy. Switch off the unit and unplug the mains cable. [. . . ]