User manual BEGLEC LED-UV212 VERSION 1.0

[. . . ] Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. CAUTION: To reduce the risk of electric shock, do not remove the top cover. [. . . ] DMX LED: is lit when the unit receives a DMX-signal 11. Master LED: is lit when the unit is switched as master 12. MENU button: used to select the different menu items 13. DOWN button: to go back in the menu and to lower the values shown on the display. ENTER button: used to confirm your choice. Electrical installation for two or more units in DMX-mode: The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to "daisy chain" your DMX controller and all the connected units with a good quality balanced cable. To prevent strange behavior of the light effects, due to interferences, you must use a 90 to 120 terminator at the end of the chain. Never use Y-splitter cables, this simply won't work!Make sure that all units are connected to the mains. Each light effect in the chain needs to have its proper start address so it knows which commands from the controller it has to decode. In the section HOW TO SETUP you will learn how to set the DMX addresses. Remember that each projector uses 1 or 2 channels, a possible address setup for 2ch mode could be: unit1 = 001 ~ unit2 = 003 ~ unit3 = 005 ~ unit4 = 007 ~ etc. Important: The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. electrical installation for 1 standalone unit: Insert the mains cable. The unit starts working immediately in the last selected stand-alone mode. Refer to chapter HOW TO SETUP to learn how to switch between static and sound mode. Remark: You can connect a CA-8 remote controller to the unit if you want to have more control. Electrical installation for two or more units in master/slave: Connect 2 to maximum 16 units together using good quality balanced microphone cables. The unit that has no cable connected to its DMX-input is the "master", the others are the slave units. Make sure that all units are connected to the mains. Remark: You can connect a CA-8 remote controller to the master unit if you want to have more control over the master/slave operation. [. . . ] Make sure the area below the installation place is free from unwanted persons during servicing. Switch off the unit, unplug the mains cable and wait until the unit has been cooled down. During inspection the following points should be checked: All screws used for installing the device and any of its parts should be tightly fastened and may not be corroded. Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. [. . . ]