User manual BEGLEC LIGHT SPLASH 2 PENGUIN VERSION 1.2

[. . . ] â· The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. â· Check that the available voltage is not higher than the one stated on the rear panel of the unit. â· The power cord should always be in perfect condition: switch the unit immediately off when the power cord is squashed or damaged. â· Never let the power-cord come into contact with other cables! [. . . ] â· Don't cover any ventilation openings as this may result in overheating. â· Prevent use in dusty environments and clean the unit regularly. â· Keep the unit away from children. â· Inexperienced persons should not operate this device. Don't use this unit at higher ambient temperatures. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Always unplug the unit before servicing!Always use the same type of spare parts (bulbs, fuses, etc. ) When replacing parts, please only genuine spare parts. Wait for about 10 minutes until the unit has been cooled down. Use a screwdriver to unscrew the screws that close lamp compartment of the fixture. Hold the lamp socket while unplugging the lamp instead of pulling the cable!Hold the lamp socket while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Never install lamps with a higher wattage!Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. Don't touch the bulb with bare hands! this drastically shortens the lifespan of the lamp. If you touched the lamp, clean it with a cloth and a little denatured alcohol. Be sure that the wires don't touch the lamp. [. . . ] â· The interior of the device should be cleaned annually using a vacuum cleaner or air-jet. â· The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics. â· Clean with a soft cloth using normal glass cleaning products. [. . . ]