User manual BEGLEC LM430 V1.1

[. . . ] Total load = 3600W) Suitable for both inductive and resistive loads. LM430: no internal dimmer packs, to be used with external DMX power units. 4 extra switch channels to switch light effects on/off via optional DMX switch pack (ex. SW416) 4 user modes: Individual manual dimming on all 4 channels (stage lighting) 4 Channel light modulator (high, mid, bass, anti-bass) 9 built-in 4channel chaser programs: audio controlled (built-in micro or external cinch audio input) static with user selectable speed on fader Individual dimmer faders on each channel, each with flash buttons. [. . . ] In order to avoid a hazard, the unit shall only be used with the AC-adaptor delivered with it. If the ACadaptor is damaged, a same model adaptor shall be used only. LM440G ~ LM440F must be earthed to in order comply with safety regulations. In order to prevent electric shock, do not open the cover. Apart from the mains fuse there are no user serviceable parts inside. never repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the appliance and contact your dealer immediately. Please use the original packing when the device is to be transported. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. POWER SWITCH: used to switch the unit ON/OFF. DIMMER CHANNELS: these are 4 faders used to set the individual dimming levels of the 4 channels. Below each fader there's a flash button to set the output of the corresponding channel to 100% (full) for as long as the button is pressed. The flash buttons all have backlight so you can easily monitor the output of each channel. SWITCH CHANNELS: these buttons are used to switch 4 individual light effects ON/OFF. To be able to use these buttons you must connect a separate switch pack to the DMX-output of the unit. (DMX address on the switch pack must be set to 005) 4. MODE SELECT: used to select 1 of the 4 user modes: HOLD DIM: This mode can be used to control the dimming levels of projectors on a small stage. The 4 faders (2) can be used to set the dimming level of each channel individually. HOLD SOUND: the music is divided into 4 different frequency ranges (bass, middle, high, antibass). [. . . ] When the problem is solved, simply push the button to reset the circuit breaker. CHANNEL OUTPUTS: (only on LM440G ~ LM440F) Each channel output has its own output socket to connect any resistive and/or inductive (PAR36) projector(s). Always replace a blown fuse with a fuse that has the same characteristics!It's very important to know that the maximum load for each channel is rated at 8A or 1750Watts. [. . . ]