User manual BEGLEC LOUNGE LASER VERSION 1.1

[. . . ] Using special grating technology the beams are split-up in a lot of separate laser beams pointing in all directions to create an amazing, room filling effect. Strobe control for each laser + dimmer for the LED projector Perfect for projections on walls and ceilings in bars, clubs, discotheques, hotels, etc Key actuated on/off switch for additional safety Complies to EN/IEC 60825-1 for Laser Safety Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. [. . . ] In the event of serious operating problems, stop using the fixture and contact your dealer immediately. The housing and the lenses must be replaced if they are visibly damaged. Please use the original packing when the device is to be transported. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Important: Never look directly into the light source!Don't use the effect in the presence of persons suffering from epilepsy. According to the EN 60825-1:1994 + A1:2002 + A2:2002 regulations, this laser falls under the classification 3B. Laser radiation can cause eye damage and/or skin damage. All protective measures for a safe operation of this laser must be applied. This product is a so-called show laser, emitting radiation with a wavelength spectrum between 400 and 700 nm and producing lighting effects for shows. Due to the construction of this laser, the beam is moved so fast, that it can only hit the eye very short. This is why the use of this laser for a Laser-Light-Show can be regarded as save. Never direct the laser beam to people or animals and never leave this device running unattended. The operation of a class 3B show laser is only allowed if the operation is controlled by a skilled and well-trained operator. Depending on the classification, operating a laser product can produce laser radiation that may cause permanent eye damage and/or skin damage. The legal instructions for using a laser product vary from CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. This symbol means: indoor use only This symbol means: Read instructions This symbol means: Safety Class II appliance The user must always inform himself on the legal instructions valid in his country and apply them to his situation. Please note that JB SYSTEMS cannot be made liable for damages caused by incorrect installations and unskilled operation! The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. [. . . ] The fixture must be fixed at least 50cm from surrounding walls. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. [. . . ]