User manual BEGLEC LP-8115 V1.0

[. . . ] This device has been designed to produce decorative effect lighting and is used in light show systems. A lightweight RGB LED projector to be used with the LED MANAGER (special DMX power supply) 81 LEDS (Red 26pcs + Green 26pcs + Blue 29pcs) behind a sturdy 15cm x 15cm cover. Two beam angles available: 15° and 40° Can be built in any wall and/or ceiling Hanging bracket included for easy fixing on truss or any surface Very easy electrical 4-wire connection Low power consumption, only 10watts!Can be used in discotheques, pubs, lounges, buildings, parkings, homes, etc. [. . . ] To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. Don't place metal objects or spill liquid inside the unit. electric shock or malfunction may result. If a foreign object enters the unit, immediately disconnect the mains power. Prevent use in dusty environments and clean the unit regularly. Inexperienced persons should not operate this device. maximum save ambient temperature is 40°C. Don't use this unit at higher ambient temperatures. Make sure the area below the installation place is free from unwanted persons during installation and servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. Don't connect the unit to any dimmer pack. Please use the original packing when the device is to be transported. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Installing the LP-8115/LP-8140 in a mounting panel USING THE SPRING CLIPS: IMPORTANT NOTE: Before you start installing the unit, be sure to remove the hanging bracket first ! Before installing this unit, please take note of following information: The diameter of the hole cutout has to be 125mm x 125mm The thickness of the mounting panel (ceiling) can be up to 15mm Make sure the area below the installation place is free from unwanted persons while installing How to install the unit: Install the Spring Clips on both sides of the enclosure. Make sure you make the electrical connections before you install the unit in the mounting panel!Press both Spring Clips upwards (see picture A). [. . . ] The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. Make sure the area below the installation place is free from unwanted persons during servicing. During inspection the following points should be checked: All screws used for installing the device and any of its parts should be tightly fastened and may not be corroded. [. . . ]