User manual BEGLEC LYNX VERSION 1.0

[. . . ] `t Hofveld 2 ~ B1702 Groot-Bijgaarden ~ Belgium Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Never expose the lens to direct sunlight, even for a short period. This may damage the light effect or even cause fire!EN - DISPOSAL OF THE DEVICE Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. [. . . ] Always use a certified safety cable (number 3 on the picture) that can hold 12 times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. SENSITIVITY: Used to adjust the sensitivity of the micro when the unit is used in standalone or master/slave mode. MAINS FUSE: Always replace this fuse with a fuse that has the same characteristics!To select any of the functions, press the MENU button up to when the required one is shown on the display. After 8 seconds the display will automatically return to the main functions without any change. To go back to the functions without any change press the MENU button for about 2 seconds. Once the correct address shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again for about 2 seconds for about 2 seconds. Show Mode Used to choose the Show mode when used in standalone or master/slave mode. The spot is always projecting to the audience's direction; i. Tilt movement angle: 90° (60° above horizon; 30° below horizon. ) Show 4: Fixture is fixed under ceiling. The spot is mainly projecting in front of the stage. pan movement angle (left to right to left):160°. Tilt movement angle: 90° (vertically, front 75°; back 15°) Once the right mode shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again for about 2 seconds. REMOTE CONTROL INPUT: Used to connect a simple CA-8 hand controller while the unit is used in standalone or master/slave mode. [. . . ] Each light effect in the chain needs to have its proper starting address so it knows which commands from the controller it has to decode. In the next section you will learn how to set the DMX addresses. SLAVES have 2 working options: The other units are set to slave mode (slave-LED is constantly on). In order to create a great light show you can introduce contrast movements (pan/tilt of slave is inversed) In the menu of the slave units you can go to option and select: o Normal slave: slave works in sync with the master. [. . . ]