User manual BEGLEC MICRO SCAN LED VERSION 1.0

[. . . ] Virtually no heat production: no noisy fans Lightweight (no lamp transformers needed) Big light output and sharp gobos, thanks to excellent optics 0-100% dimming and ultra fast strobe function Excellent built-in programs for wonderful, ever changing, light shows: DMX-control: 5 channels (pan, tilt, color/gobo, strobe, dimmer) Standalone: sound activated with internal mic Master/slave: wonderful synchronized shows 8 gobos + open, equipped with gobo shaking feature 2 optional remote controllers available: CA-8: wired remote for improved master/slave control RF-8 Set: wireless RF-remote for improved master/slave control (RF-8SET = RF-8T "transmitter" + RF-8R "receiver") Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. [. . . ] never repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the fixture and contact your dealer immediately. The housing and the lenses must be replaced if they are visibly damaged. Please use the original packing when the device is to be transported. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Important: Never look directly into the light source!Don't use the effect in the presence of persons suffering from epilepsy. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Standalone 1unit: Just connect the unit to the mains and put on some music. The unit will start working automatically to the rhythm of the music. Two or more units in master/slave setup: Connect 2 or more units together using good quality balanced XLR microphone cables . The unit that has no cable connected to its input will react as master; the others are the slave units. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. Din-5pin input, used to connect an optional wireless receiver, named RF-8R. DIP switches, used to set the DMX-starting address of the unit. This input receives instructions from a DMX-controller or from another Led Micro Scan light effect when used in master/slave mode. DMX output: 3pin female XLR-connector used to connect the Led Micro Scan with the next unit in the DMX chain or with another Led Micro Scan when used in master/slave mode. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. [. . . ] Clean the internal optics at least every 90 days. Mains Input: Fuse: Sound Control: DMX connections: DMX channels: Lamp: Size: Weight: AC 100 ~ 240V, 50/60Hz 250V 2A fast blow (20mm glass) Internal microphone 3pin XLR male / female 5 CREE 10W White LED 333 x 156 x 177mm (see drawing) 3, 0kg Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. Make sure the area below the installation place is free from unwanted persons during servicing. Switch off the unit, unplug the mains cable and wait until the unit has been cooled down. [. . . ]