User manual BEGLEC MINI COLOR 7 TC V1.1

[. . . ] 3. 4--AUTO. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10. 3. 5--ADDRESS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10. 3. 6--RUN. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10. [. . . ] This product must be installed by a qualified professional. Always operate the equipment as described in the user manual. A minimum distance of 0. 5m must be maintained between the equipment and combustible surface. The product must always be placed in a well ventilated area. Always make sure that the equipment is installed securely. DO NOT stand close to the equipment and stare directly into the LED light source. Always disconnect the power supply before attempting and maintenance. Always make sure that the supporting structure is solid and can support the combined weight of the products. The earth wire must always be connected to the ground. Do not touch the power cables if your hands are wet. ATTENTION This product left the place of manufacture in perfect condition. In order to maintain this condition and for safe operation, the user must always follow the instructions and safety warnings described in this user manual. Avoid shaking or strong impacts to any part of the equipment. Make sure that all parts of the equipment are kept clean and free of dust. Always make sure that the power connections are connected correct and secure. If there is any malfunction of the equipment, contact your distributor immediately. When transferring the product, it is advisable to use the original packaging in which the product left the factory. [. . . ] When [UC] is selected, the RGB output are adjusted to a standard preset universal color which balances fixtures from different generations. . The factory default setting is [UC] on. 3. 13 SAVE Only the main menu and the Auto-programs submenu can be protected Repower the unit, it will back to the main menu 3 DISPLAY PANEL OPERATION 12 2009. 12. 9 4 4. 1 USING A DMX512 CONTROLLER BASIC ADDRESSING Connect all of the units in series using standard DMX512 signal cable or the IP65 rated cable provided. It is possible to have the same DMX address or independent addresses for each fixture. 4. 2 CHANNEL ASSIGNMENT Note: This product have three DMX512 channel configuration: ARC 1+D , RGB+D and RGB+DS STAGE 1 , ARC 1 , STAGE 1 3 DISPLAY PANEL OPERATION 13 2009. 12. 9 4 USING A DMX512 CONTROLLER 14 2009. 12. 9 4 USING A DMX512 CONTROLLER 15 2009. 12. 9 4. 3 BASIC INSTRUCTIONS FOR DMX512 OPERATION (STAGE 1) MASTER DIMMER CH1 controls the intensity of the currently projected color When the slider is at the highest position (255) the intensity of the output is the maximum RED, GREEN & BLUE COLOR SELECTION CH2, CH3 & CH4 control the intensity ratio of each of the RED, GREEN & BLUE LEDs. [. . . ]