User manual BEGLEC MOC

[. . . ] Mojo Color TM Product User Guide (MOC, MOC-150) Mojo Color-One color wheel with 16 color Geni Electronics Co. , Ltd. THANK YOU! ã Copyright 2001 Geni Electronics Co. , Ltd. Product specifications may be subject to change. For more information, please visit : http://www. beglec. com Thank you for buying a Geni product. For best results, please carefully read and follow the directions in this product user manual. Congratulations! You have a great, innovative product from Geni Electronics Co. , Ltd. [. . . ] Product specifications may be subject to change. Please visit www. geni. com. tw for details. 1 10 Troubleshooting This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit operates properly, do not carry out following steps. If the effect does not operate properly, refer servicing to a technician. Getting Ready All Geni products are thoroughly tested at the factory and shipped in perfect condition. If damage has occurred during shipping or if components are missing, please contact your Geni dealer immediately. Your package should include: TM (1) One Mojo Color color changer with bracket. (2) One IEC electric mains power cord with plug. The lamp may or may not be included, depending on your GENI dealer. In most cases, the lamp is not included. No Light, No Movement - All Products Response: Suspect three potential problem areas: the power supply, the lamp, the fuse. Check that the unit is plugged into an appropriate power supply. Replace the old lamp with a new one of appropriate specifications. See directions above for replacing lamps. See directions above for replacing the fuse. Install the Lamp (ELC) Mojo Color color changer use either the GX5. 3 24V/250W lamp by Osram or the ELC lamp of identical specifications by Philips. Use only the appropriate lamp for your unit. Note that product versions that use other lamps may be offered in the future. Check your product specification label for information. TM No Response to DMX Response: Suspect the DMX dip switch setting, DMX cable or connectors, a controller malfunction, a light effect DMX card malfunction. Make sure the DMX dip switch address setting is correct. Check the DMX cable: Unplug the unit; change the DMX cable; resupply electrical power. Determine whetherthe controller or light effect is at fault. Does the controller operate other DMX products properly?If not, take the controller in for repair. [. . . ] dip switch "on") is activated. Otherwise, these channels are DMX address setting dip switches. Mojo Color DMX Channel Chart CH1 -Colors 209-255 Strobe - 1 flash per 4 seconds to 4fps 160-208 Rotation slow - fast 150-159 (16) Four-color Square 140-149 (15) White & Green 130-139 (14) Pink & White & Blue 120-129 (13) Blue & White & Green 110-119 (12) White & Yellow 100-109 (11) Red & White &Orange 90-99 (10) Pink Circle 80-89 (9) Blue Circle 70-79 (8) Light Blue Circle 60-69 (7) Orange Circle 50-59 (6) Green Circle 40-49 (5) Yellow Circle 30-39 (4) Dark Green Circle 20-29 (3) Red Circle 10-19 (2) White Circle 0-9 Shutter (1) 0 Light unit automatically shuts off 5 seconds later. Fasten the effect light onto firm trussing (Use a 30-kg rated or stronger Cclamp bolted onto the Mojo Color bracket). Leave at least one meter on all sides for air circulation. [. . . ]