User manual BEGLEC MPT 100 V 1.0

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities, please read these operating instructions very carefully. [. . . ] This CD player uses the semiconductor laser. To allow you to enjoy music at a stable operation, it is recommended to use this in a room of 5°C ­ 35°C. The compact disc player should not be adjusted or repaired by anyone except properly qualified service personnel. This unit may cause interference to radio and television reception. CLEANING THE CD-PLAYER: Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. MAINS input: connect the CD player to the 230V AC mains, using the supplied power-cord. Connect the mini-DIN9 cable between the control unit and the main unit (CD loader) Use the supplied cinch cables to connect the audio outputs of the CD player with the CD or line inputs on your mixing unit. OPEN/CLOSE button: press this button to open and close the disc tray. These buttons are disabled during playback. CONTROL connector: connect this connector to the control unit, using the supplied mini-DIN9 cable. Use the supplied cinch/cinch cable to connect this output to a CD/line input of your mixing unit. JOG WHEEL: This jog wheel serves 3 functions depending on the mode you are working in. The jog wheel acts as a slow frame search (1/75sec) control when the CD is not playing but either paused or set to a cue point. To set a new cue point, spin the wheel then press PLAY or LOOP IN when you have determined the proper position. press CUE to return to the "CUE POINT". If the track is playing and the fast search function (2) is not active, the jog wheel temporarily bends the pitch of the music up to +/-32% by rotating the wheel clockwise to speed it up or counterclockwise to slow it down. the amount of pitch change is determined by the speed of rotation. If the fast search function (2) is active, you will be able to search at a higher speed through the current track. FAST SEARCH button: press this button to toggle the function of the JOG WHEEL(1) between fast search mode ("FAS" shown in the track display) and normal mode. The fast search function is automatically turned off when the JOG WHEEL is not used for more than 10seconds. PLAY MODE: normally the JOG WHEEL is used as pitch bend tool to synchronize the beats of the playing track to another track. [. . . ] (With some practice you will be able to create perfect loops!) While the loop is playing, you can press the OUT button again to exit the loop and continue the rest of the track. It is possible to program a new loop, even when the current loop is still playing. While the loop is playing, simply press the LOOP IN button to set the starting point of the new loop. [. . . ]