User manual BEGLEC MYSTERY LED VERSION 1.0

[. . . ] `t Hofveld 2 ~ B1702 Groot-Bijgaarden ~ Belgium Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Never expose the lens to direct sunlight, even for a short period. This may damage the light effect or even cause fire!EN - DISPOSAL OF THE DEVICE Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. [. . . ] Important: The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. electrical installation for 1 standalone unit: Just insert the mains cable. The unit starts working immediately in stand-alone mode. Remark1: You can connect a CA-8 remote controller to the unit if you want to have more control. refer to "how to operate the unit" to learn how to do this. Remark2: if there's no output, please make sure to set the unit in master mode (see next chapter) Electrical installation for two or more units in master/slave: Connect 2 to maximum 16 units together using good quality balanced microphone cables. Put the first unit of the chain in master mode, the rest must be set to slave mode (SL1 or SL2). See the next chapter for more information. Make sure that all units are connected to the mains. Remark: You can connect a CA-8 remote controller to the master unit if you want to have more control over the master/slave operation Electrical installation in DMX-mode: The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to "daisy chain" your DMX controller and all the connected units with a good quality balanced cable. Both XLR-3pin and XLR-5pin connectors are used, however XLR-3pin is more popular because these cables are compatible with balanced audio cables. Mains output with IEC socket: you can use a special IEC power cable to connect this output with the mains input of the next MAGIC/MYSTERY LED for easier linking. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. Safety ring, attach the optional safety cable here 10. Slave LED: is lit when the unit is in slave mode 11. Sound LED: blinks to the rhythm of the music while the unit is in audio mode 12. DMX LED: is lit when the unit receives a DMX-signal 13. Master LED: is lit when the unit is switched as master 14. MENU button: used to select the different menu items 15. DOWN button: to go back in the menu and to lower the values shown on the display. ENTER button: used to confirm your choice. [. . . ] O 2 light show: slave works in opposite with the master. BY EASY CONTROLLER: When used in Master/slave mode we strongly advice you to use the CA-8 "Easy controller" Just connect this small controller to the 1/4" jack of the master unit, and you will be able to control the following FUNCTIONS: Standby Blackout the unit 1/ SynchroStrobe Select Show 2/ Asynchro Strobe (Show 1-8) 3/ Sound Strobe Sound/Strobe (LED OFF) Show (LED ON) Select Speed 1/ Slow 2/ Middle 3/ Fast LED blinking Press the MENU button until the display shows . Reset Press the MENU button until until the display shows . Press the ENTER button: the unit resets and all the motors will return to their home position. [. . . ]