User manual BEGLEC OIL PROJECTOR V1.1

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. [. . . ] The minimum distance between light-output and the illuminated surface must be more than 1 meters. To protect the environment, please try to recycle the packing material as much as possible. A new light effect sometimes causes some unwanted smoke and/or smell. This is normal and disappears after some minutes. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. Manual focus adjustment Manual zoom adjustment Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. Best installation distance: A projection distance of +/- 5 meters from the wall is perfect. From this distance the projection will cover an area between 2. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Always unplug the unit before servicing!Always use the same type of spare parts (bulbs, fuses, etc. ) When replacing parts, please only genuine spare parts. Wait for about 10 minutes until the unit has been cooled down. Hold the lamp socket while unplugging the lamp instead of pulling the cable!Hold the lamp socket while pressing the new lamp gently in the socket. There are 3 different lamp versions so check the label on the backside of the device to know which lamp should be used. Never install lamps with a higher wattage!Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. Don't touch the bulb with bare hands! [. . . ] In the event of serious operating problems, stop using the fixture and contact your dealer immediately. Important: Never look directly into the light source!Don't use the effect in the presence of persons suffering from epilepsy. Make sure the area below the installation place is free from unwanted persons during servicing. [. . . ]