User manual BEGLEC PB 41 POWERED BAR

[. . . ] The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. [. . . ] Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Check the contents: Check that the carton contains the following items: PB41 powered bar 4 sets of bolts and nuts used to install projectors User manual Some important instructions: Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual. To protect the environment, please try to recycle the packing material as much as possible. Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. overhead rigging requires extensive experience!Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The fixture must be fixed at least 50cm from surrounding walls. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. [. . . ] However the total load for all 4 channels may not exceed 16A or 3600Watts!POWER INPUT: mains input cable, make sure the local voltage is 230Vac and the projectors (and/or light effects) are properly connected to the channel output sockets (1) before you connect this cable to the mains wall socket. the maximum total load is 16A or 3600Watts. INPUT FUSE: Always replace this fuse with a fuse that has the same characteristics! [. . . ]