User manual BEGLEC Q3 USB V 1.0

[. . . ] `t Hofveld 2C ~ B1702 Groot-Bijgaarden ~ Belgium Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Counterweight Head shell Cartridge Mains power cable Dust cover USB cable Thank you for buying this JB Systems product. To take full advantage of all possibilities, please read these operating instructions very carefully. [. . . ] Install the unit on a perfectly horizontal and very stable surface. Be sure the turntable, including its audio and mains cords, does not touch any vibrating materials. Take special care when using the unit while it is installed in a carrying case. CLEANING THE TURNTABLE: Clean by wiping with a cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. This makes it easier to manipulate the record for scratch performances. TARGET LIGHT: Target light used to locate the exact place on your record when used in a dark place. REVERSE BUTTON: Press this button to reverse the platter rotation, press this button again to end the reverse mode. (normally used for beat mixing) Press again for +/-20% speed range. QUARTZ LOCK BUTTON: When the QUARTZ Button is pressed, the exact center speed (0%) is enforced, even when the pitch slider is not in the middle. When the slider is in its middle position, the led next to the pitch slider will turn on to indicate that the turntable is locked to the exact center speed. When the slider is not in the middle the led turns off. Attention: take care that the Quartz lock button is switched off. SINGLE ADAPTER: Place this adapter on the platter for playing 7" records with large center holes. POWER CORD CONNECTOR: Used to connect to the mains, using the supplied power cord. PHONO/LINE SWITCH: Depending on the position of the phono/line switch, you can connect the turntable to any phono or line level input. PHONO/LINE OUTPUT: Connect the turntable to any phono or line level input. Be sure to put the phono/line switch in the correct position. To start playback, gently place the stylus on the record using the head shell finger support. Do not drop the stylus onto the record as this may cause damage to the diamond tip and to the record. For the correct stylus pressure, please refer to the user manual of your cartridge. Setting up the stylus pressure: Make sure the cartridge is well fitted and its needle protector is removed. [. . . ] Use the same settings as on the picture and click OK. If you want you can perform all kinds of extra effects on the recorded track. For these tasks however you have to consult the Audacity manuals and tutorials. SAVING A TRACK: You can save a file in different ways. [. . . ]