User manual BEGLEC ROVER VERSION 1.1

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Hanging bracket with 2 knobs · Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. [. . . ] Don't use the effect in the presence of persons suffering from epilepsy. DMX output: 3pin female XLR-connector used to connect the Winner (or Rover) with the next unit in the DMX chain or with another Winner (or Rover) when used in master/slave mode. Button used to control the music sensitivity In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Always unplug the unit before servicing!Always use the same type of spare parts (bulbs, fuses, etc. ) When replacing parts, please only genuine spare parts. Switch off the unit and unplug the mains cable. Wait for about 10 minutes until the unit has been cooled down. Use a screwdriver to unscrew the screw that closes lamp compartment of the fixture. Hold the lamp socket while unplugging the lamp instead of pulling the cable!Hold the lamp socket while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Never install lamps with a higher wattage!Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. Don't touch the bulb inside the reflector of the lamp with bare hands! this drastically shortens the lifespan of the lamp. If you touched the lamp, clean it with a cloth and a little denatured alcohol. Be sure that the wires don't touch the lamp. Close the lamp compartment with the screw. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. Lamp compartment, to be opened with this screw. [. . . ] The unit that has no cable connected to its input will react as master; the others are the slave units. You don't have to worry about the settings of the DMX DIP-switches!It is only possible to inverse the behavior of a slave unit by changing the position of DIP-switch n°10. Connect the optional CA-8 controller for more control: The CA-8 controller can only be used in standalone or master/slave mode. [. . . ]