User manual BEGLEC SMX-2 V 1.4

[. . . ] Reproduction or publication of the content, even portions, in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Congratulations and thank you for buying this SYNQ product. Please read these operating instructions carefully so you will know how to operate this product properly. [. . . ] You can easily change the flanger time (cycle) with the "presets"(23). These presets can be tuned with the "X-parameter knob"(24) in a range from 100mSec up to 16Sec. With the "Yparameter knob"(25) you can change the flanger feedback level. Hint: Every time you push the same preset button(23) you will restart the flanger cycle. This gives a nice "extra touch" to the effect. The mixer comes with 5 standard filter presets but you can easily adjust these presets(23) with the "X-parameter knob"(24) in a range from low pass filter (LPF) @ 50Hz (display shows: L 0. With the "Y-parameter knob"(25) you can change the filter resonance level. (This is the Q-factor of the filter , it changes the impact of the filter on a selected frequency). You can replace the standard presets with your own parameters, simply by pressing the "X-parameter knob"(24) and one of the 5 preset buttons (23) together. aUTO FILTER: This is an automatic low pass filter (LPF). The cutoff frequency varies in cycles from 20kHz down to 50Hz. With the preset buttons(23) you can select filter cycles that are beat synchronized. (example: press the preset called "8" it will take 8beats for the filter to change its cutoff frequency from 20kHz to 50Hz and back) The presets can be tuned with the "X-parameter knob"(24) in a range from 100mSec up to 16Sec. With the "Y-parameter knob"(25) you can change the filter resonance level. (This is the Q-factor of the filter , it changes the impact of the filter on a selected frequency) REVERB: This effect is best described as the "church effect". Imagine you play music in a church or in a very big, empty hall: the reverb you get from all kinds of reflections against the walls is digitally simulated with this effect. With the preset buttons(23) you can select 5 predefined reverb times. These reverb times can be tuned with the "X-parameter knob"(24) in a range from 0% to 100% in steps of 1%. With the "Y-parameter knob"(25) you can change the balance between the original and the reverb sound. You can replace the standard presets with your own parameters, simply by pressing the "X-parameter knob"(24) and one of the 5 preset buttons (23) together. tRANS: Automatically cuts the sound to the rhythm of the beat. With the "presets"(23) you can choose the length of the cutting cycles. [. . . ] Gently remove the fader and the cover plate from their position. Unplug the cross fader from the cable (unplug the cable by pulling the connector, NOT the cable! ) Press the new cross fader on the cable. Put the cross fader back in place with the small cover plate and the 2 screws. [. . . ]