User manual BEGLEC SPACE COLOR VERSION 1.2

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. To protect the environment, please try to recycle the packing material as much as possible. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. [. . . ] The operation of a class 3B show laser is only allowed if the operation is controlled by a skilled and well-trained operator. Depending on the classification, operating a laser product can produce laser radiation that may cause permanent eye damage and/or skin damage. The legal instructions for using a laser product vary from country to country. The user must always inform himself on the legal instructions valid in his country and apply them to his situation. Please note that JB SYSTEMS cannot be made liable for damages caused by incorrect installations and unskilled operation!INTERLOCK input: used to connect the optional emergency stop switch (see picture). When you push this switch the laser beam will disappear immediately. For your own safety we strongly recommend to connect this optional switch!INTERNAL MICROPHONE: The built-in microphone is used to synchronize the laser show to the beat of the music. This input receives instructions from a DMX-controller. DMX OUTPUT: 3pin female XLR-connector used to connect the Space Color laser with the next unit in the DMX chain. DISPLAY: shows the selected DMX address when the unit is in DMX-mode. Shows 3 horizontal lines when the unit is in stand-alone mode. DIP-SWITCHES: switches 1~8 are used to set the DMX address between 000 and 255. Switch 9 is not used and switch 10 is used to select stand-alone or DMX mode. AUTO/MUSIC SWITCH: when the unit is used in stand-alone mode, this switch sets the laser in music mode (patterns move to the rhythm of the beat) or auto mode (patterns move automatically) 10. SAFETY EYE: used to attach a safety cable when the unit is rigged (see paragraph "overhead rigging" 11. MUSIC INPUT SENSITIVITY: This potentiometer is used to adjust the music input sensitivity. Turn the potentiometer until the laser works in sync with the music. COOLING FAN: used to cool the components inside the enclosure. Make sure to never cover this fan outlet!MAINS INPUT: with IEC socket and integrated fuse holder and power switch, connect the supplied mains cable here. [. . . ] Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The fixture must be fixed at least 50cm from surrounding walls. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. [. . . ]