User manual BEGLEC SUPER WINNER VERSION 1.0

[. . . ] If a foreign object enters the unit, immediately disconnect the mains power. Locate the fixture in a well ventilated spot, away from any flammable materials and/or liquids. The fixture must be fixed at least 50cm from surrounding walls. Don't cover any ventilation openings as this may result in overheating. [. . . ] Always unplug the unit before servicing!Always use the same type of spare parts (bulbs, fuses, etc. ) When replacing parts, please only genuine spare parts. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. Lamp compartment, to be opened with this screw. DIP switches, used to set the DMX-starting address of the unit. This input receives instructions from a DMX-controller or from another Winner light effect when used in master/slave mode. DMX output: 3pin female XLR-connector used to connect the Winner with the next unit in the DMX chain or with another Winner when used in master/slave mode. Button used to control the music sensitivity · Switch off the unit and unplug the mains cable. Wait for about 10 minutes until the unit has been cooled down. Use a screwdriver to unscrew the screw that closes lamp compartment of the fixture. Unscrew the 2 wires from the wire terminal Install the 2 wires from the new lamp in the wire terminal and make sure to fasten the terminals well. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Never install lamps with a higher wattage!Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. Don't touch the bulb inside the reflector of the lamp with bare hands! this drastically shortens the lifespan of the lamp. If you touched the lamp, clean it with a cloth and a little denatured alcohol. Be sure that the wires don't touch the lamp. Close the lamp compartment with the screw. Important: The installation must be carried out by qualified service personal only. [. . . ] When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. The interior of the device should be cleaned annually using a vacuum cleaner or air-jet. [. . . ]