User manual BEGLEC SW-416 V1.0

[. . . ] Thanks to the 19" brackets and indicators on front and back side this switch pack can be used in different ways 4 DMX channels, easily set by dip switches This symbol means: indoor use only. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. [. . . ] never repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the appliance and contact your dealer immediately. Please use the original packing when the device is to be transported. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Check the contents: Check that the carton contains the following items: User manual SW-416 Unit ( Two 19" brackets mounted ) Some important instructions: Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual. To protect the environment, please try to recycle the packing material as much as possible. Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. Channel LEDs: These Leds show which of the channels are on 1. Power Cord : supplies main power to the fixture. dMX Input: receives incoming DMX signal DMX Output: transmits the incoming DMX signal to another DMX fixture. Dip Switches: These switches are used to assign a DMX address to the unit. Power Output: It is used to connect four different fixtures, such as lighting effects. channel LEDs: is lit when the channel is on. [. . . ] The unit is supplied with a power plug appropriate to its voltage and destination. Should any other connections be required they must be carried out with the following configuration. The switch pack is equipped with 4 DMX channels and can be controlled by universal DMX controller. Each channel can be used for the ON/OFF control of different equipment, such as lightings effects. [. . . ]