User manual BEGLEC T2 V 1.1

[. . . ] The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Thank you for buying this JB Systems product. [. . . ] MOTOR OFF BUTTON: Normally the platter stops while you press the start/stop button (1). In this case the platter stops quite fast due to the electronic brake. Press the "motor off" button if you want the platter to slow down more smoothly. as long as the motor is switched off , the led of the button flashes. Press the button again to switch the motor back on. TARGET LIGHT: White led target light used to locate the exact place on your record when used in a dark place. REVERSE BUTTON: Press this button to reverse the platter rotation, press this button again to end the reverse mode. When the slider is in its middle position, the blue led next to the pitch slider will turn on to indicate that the turntable is locked to the exact center speed. 45RPM ADAPTER: Place this adapter on the platter for playing 7" records with large center holes. POWER CORD CONNECTOR: Used to connect to the mains, using the supplied power cord. In most cases you need to install a wire between the GND connection on the turntable and the corresponding GND connector on the DJ-mixer. When you forget to make this connection you may encounter problems with humming noises. PHONO OUTPUT: Connect the turntable to any phono input, using the supplied cinch/cinch cable. To start playback, gently place the stylus on the record using the head shell finger support. Do not drop the stylus onto the record as this may cause damage to the diamond tip and to the record. For the correct stylus pressure, please refer to the user manual of your cartridge. Setting up the stylus pressure: Make sure the cartridge is well fitted and its needle protector is removed. Put a record on the platter and make sure the anti-skate is set to zero. [. . . ] This prevents the tone arm from accidentally turning towards the platter and damaging the needle of the cartridge. HEAD SHELL LOCKING NUT: Attach the head shell by inserting it into the front end of the tone arm and then turn the locking nut clockwise. During installation, attach the stylus protector to guard the stylus tip from damage. [. . . ]