User manual BEGLEC T3 V 1.2

[. . . ] If a foreign object enters the unit, immediately disconnect the mains power. No naked flame sources, such as lighted candles, should be placed on the appliance. Don't cover any ventilation openings as this may result in overheating. Prevent use in dusty environments and clean the unit regularly. [. . . ] When the turntable is used in a loud-sound environment, for example near speakers, sound skip and feedback may occur. Install the unit on a perfectly horizontal and very stable surface. Be sure the turntable, including its audio and mains cords, does not touch any vibrating materials. Take special care when using the unit while it is installed in a carrying case. Because of its two start/stop buttons the T3 turntable can be used in both traditional and battle style setups: CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Battle style setup: Mostly used for scratching and other aggressive mixing techniques This symbol means: indoor use only. This symbol means: Safety Class II appliance To prevent fire or shock hazard, do not expose this appliance to rain or moisture. CLEANING THE TURNTABLE: Clean by wiping with a cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. This makes it easier to manipulate the record for scratch performances. MOTOR OFF BUTTON: Normally the platter stops while you press the start/stop button (1). In this case the platter stops quite fast due to the electronic brake. Press the "motor off" button if you want the platter to slow down more smoothly. as long as the motor is switched off , the led of the button flashes. Press the button again to switch the motor back on. TARGET LIGHT: White led target light used to locate the exact place on your record when used in a dark place. REVERSE BUTTON: Press this button to reverse the platter rotation, press this button again to end the reverse mode. (normally used for beat mixing) Press again for +/-12% speed range. The next time you press this button you will switch again to +/-8% etc. QUARTZ LOCK BUTTON: When the QUARTZ Button is pressed, the exact center speed (0%) is enforced, even when the pitch slider is not in the middle. [. . . ] For standard playback simply turn the anti-skate knob to the same number as the stylus pressure reads in grams. TONE ARM CLAMP & REST: Use this rest for the tone arm while changing a record. Attach the tone arm to the rest using the clamp when the turntable is not used or when it is transported. This prevents the tone arm from accidentally turning towards the platter and damaging the needle of the cartridge. [. . . ]