User manual BEGLEC Z-3000II

[. . . ] If moisture, water, or fog fluid gets inside the housing, immediately unplug the unit and contact a service technician or your ANTARI dealer before using it again. Refer to your ANTARI dealer or other qualified service personnel. For adult use only and must be installed out of the reach of children. Never leave the unit running unattended. [. . . ] Always drain tank before mailing or transporting this unit. If fog liquid comes in contact with skin or eyes, rinse thoroughly with water. Note: Pay attention to all warning labels and instructions printed on the exterior of your ANTARI Fog Machine Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact. The shipping carton should contain the following items: 1. One unit of One unit of Z-Series II Fog Machine Power cord Z-20 multi-function remote control with attached cord User Manual If any equipment is missing contact your ANTARI dealer immediately. Before beginning your initial setup on ANTARI Z-1500II or Z-3000II Fog Machine, make sure that there is no evident damage caused by transportation. In the event that the unit's housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your ANTARI dealer for assistance. Fill with ANTARI fog liquid or other high-quality water-based fog fluid recommended by ANTARI dealer. Any other types of fluid can damage the unit resulting in spitting and serious clogging problem. When filled, place cap back on liquid tank. Its LCD displays current operating parameters, which are automatically stored in non-volatile memory, allowing the machine to be powered down without losing function settings. The Plug should be in a position that is accessible when using the machine. Plug power cord into a grounded electrical outlet. Turn the power switch to "ON" on the back of the machine. Warm-up is completed when the display on the control module shows "Ready to Fog" The control unit display will display "Warming up" and "Ready to fog" as the machine re-heats to the proper Do not allow the fog liquid to become contaminated. Always replace the caps on the fog liquid container and the fog machine liquid tank immediately after filling. After every 40 hours of continuous operation, it is recommended to run a cleaning solution composed of 80% distilled water and 20% white vinegar through the system to prevent the accumulation of particulate matter in the heating element. the recommended cleaning regimen is as follows: 1. Run unit in a well-ventilated area until tank is almost empty. Run the machine briefly to clear any cleaning solution from the pump and heater. Do not operate the fog machine without liquid at any time. Note: All fog machines are prone to clogging due to the thick consistency of fog liquid and the high temperature at which it vaporizes. [. . . ] each channel has a value range of 0 to 255. Timer functions such as duration and interval can be programmed using the DMX controller or the DMX control software being used by lighting and effects operator. If Channel A has a value from 0 to 5, the unit is OFF. between the values 6 to 249 the volume of fog output is regulated. [. . . ]