User manual BEHRINGER ADA8000

[. . . ] ADA8000 Users Manual Version 1. 0 December 2002 ULTRAGAIN PRO-8 DIGITAL ENGLISH ULTRAGAIN PRO-8 DIGITAL ADA8000 SAFETY PRECAUTIONS DETAILED SAFETY INSTRUCTIONS: All the safety and operation instructions should be read before the device is operated. Retain Instructions: The safety and operating instructions should be retained for future reference. Heed Warnings: All warnings on the device and in the operating instructions should be adhered to. CAUTION: To reduce the risk of electric shock, do not remove the cover (or back). [. . . ] As long as the ADA8000 functions as master, sending a clock signal, the SYNC MASTER LED lights up. The appropriate setting can be made on the rear (see ). When the ADA8000 is synchronized externally (either ADAT® or wordclock IN), the SYNC LOCKED-LED lights up. Press the +48 V switch to provide condenser microphones which are connected to the MIC IN inputs with the required phantom power. Dynamic microphones do not require this external power supply. When the switch is depressed, phantom power is active on all inputs. + Before plugging the unit into a power socket, please make sure you have selected the correct voltage: The fuse compartment near the power plug socket contains three triangular markings. Two of these triangles are opposite one another. The voltage indicated adjacent to these markings is the voltage to which your unit has been set up, and can be altered by rotating the fuse compartment by 180°. ATTENTION: This does not apply to export models that were for example manufactured only for use with 120 V! + + If you alter the units voltage, you must change the fuses accordingly. The correct value of the fuses needed can be found in the chapter TECHNICAL DATA. Faulty fuses must be replaced with fuses of appropriate rating without exception!The correct value of the fuses needed can be found in the chapter TECHNICAL DATA. Power is delivered via the cable enclosed with the unit. All requiered safety precautions have been adhered to. + Please make sure that the unit is grounded at all times. For your own protection, you should never tamper with the grounding of the cable or the unit itself. 1. 1. 3 Warranty Please take a few minutes and send us the completely filled out warranty card within 14 days of the date of purchase. You may also register online at www. behringer. com. Please use exclusively high-grade cabels. The audio connectors of your ADA8000 are electronically balanced and ensure automatic hum and noise reduction. Needless to say, even devices with unbalanced outputs can be connected to the balanced in/outputs of your ADA8000. For this purpose, please use either mono plugs or connect the ring of stereo plugs with the sleeve (when using XLR connectors, pin 1 and pin 3 have to be bridged). Fig. 2. 3: ADAT® IN/OUT and wordclock SYNC All analog input signals are converted into the standard ADAT® format and can be taken at the 8-CHANNEL DIGITAL OUT. This output can be used to feed an ADAT® recorder or any other device featuring an ADAT® input. Please note that a signal present at the DIGITAL IN will not be routed to the DIGITAL OUT. [. . . ] ADAT is a registered trademark of the Alesis Corporation and is in no way associated or affiliated with BEHRINGER. © 2002 BEHRINGER Spezielle Studiotechnik GmbH. BEHRINGER Spezielle Studiotechnik GmbH, Hanns-Martin-Schleyer-Str. 36-38, 47877 Willich-Münchheide II, Germany Tel. [. . . ]