User manual BEHRINGER AMP800

[. . . ] AMP800 User's Manual Version 1. 1 October 2005 MINIAMP MINIAMP AMP800 IMPORTANT SAFETY INSTRUCTIONS CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. To reduce the risk of fire or electric shock, do not expose this appliance to rain and moisture. The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. [. . . ] To arrange for warranty service, please contact the retailer from whom the equipment was purchased. Should your BEHRINGER dealer not be located in your vicinity, you may directly contact one of our subsidiaries. Corresponding contact information is included in the original equipment packaging (Global Contact Information/European Contact Information). Should your country not be listed, please contact the distributor nearest you. A list of distributors can be found in the support area of our website (www. behringer. com/support). Registering your purchase and equipment with us helps us process your repair claims quicker and more efficiently. CONTROL ELEMENTS The AMP800 is a headphone amplifier that includes 4 Headphone Channels, so you can share the AMP800 with other musicians. In addition, each musician can choose between 2 audio channels: Input Channel A and Input Channel B. Ensure that only qualified personnel set up and operate the AMP800. 2. 1 Front panel This section describes how to use the front panel of the AMP800, illustrated as follows: Fig. 2. 1: AMP800 front panel In the previous illustration, each control element is associated with a callout, for example this section, use these callouts to identify details about each control element. For each Input Channel (A and B), the front panel includes control elements manage the signal in each of these Input Channels, use these control elements: and . To LEVEL control: To adjust the input level of a signal, turn this control toward 0 (minimum level) or, alternatively 6 (maximum level). CONTROL ELEMENTS MINIAMP AMP800 BALANCE control: To adjust the stereo image of a signal, turn this control toward L (left) or, alternatively R (right). A + B meter: To monitor the combined level of both signals (A and B), use this meter. An LED glows next to the value that identifies the combined level (-24 dB to 0 dB). If the signal is too strong, the CLIP LED glows. Most of the time, the optimal level is 0 dB (a full signal). For each Headphone Channel (1, 2, 3, and 4), the front panel includes control elements . To manage each Headphone Channel, use these control elements: through INPUT button: To select an Input Channel, push this button. When you listen to: Input Channel A, this button is not pushed in and not lit Input Channel B, this button is pushed in and lit PHONES LEVEL control: To adjust the level of a headphone signal, turn this control toward 0 (minimum volume) or, alternatively 6 (maximum volume). CH meter: To monitor the level of a headphone signal, use this meter. An LED glows next to the value that identifies the headphone volume (-24 dB to 0 dB). [. . . ] connection or operation of the unit in any way that does not comply with the technical or safety regulations applicable in the country where the product is used. damages/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. 6. If an inspection of the product by BEHRINGER shows that the defect in question is not covered by the warranty, the inspection costs are payable by the customer. Products which do not meet the terms of this warranty will be repaired exclusively at the buyer's expense. [. . . ]