User manual BEHRINGER B1520DSP

[. . . ] B1520DSP User manual V01 2007-07 EUROLIVE EUROLIVE B1520DSP Important safety instructions 1) Read these instructions. 5) Do not use this apparatus near water. Caution: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. [. . . ] (12) A noise-gate allows you to eliminate unwanted noise during signal pauses. This is done by a circuit that mutes the output when the signal level drops below a preset threshold. Use the NOISE GATE control to determine the threshold below which the noise-gate closes. (13) The TH LED lights up as soon as the signal level drops below the threshold value adjusted with the NOISE GATE control (12) (the noise-gate closes). To avoid feedback, it is recommended that you carefully select and direct the microphones used. Basically, you should use microphones with a high directivity, i. e. with a cardioid or hypercardioid polar pattern. Never hold a microphone so that its main pick-up area points directly towards the loudspeaker. When you hold it with its less sensitive side towards the speaker box, you can move closer to the speaker. + If you encounter persistent feedback problems, consider using our proven FEEDBACK DESTROYER PRO FBQ2496 for line-level signals. For signals with line or microphone level, we recommend our BEHRINGER SHARK DSP110. 4. Application examples 4. 1 Presentations With just one B1520DSP and one or two dynamic microphones, you can set up a basic audio system with very little effort. Thanks to the built-in mixer section, you can connect the microphones directly to the B1520DSP. Mount the B1520DSP on a speaker stand for optimum presentation and intelligibility of announcements. If one B1520DSP is not enough, you can, of course, use a second or even more loudspeakers. Connecting microphones: = Turn the LEVEL controls ( 3 ) fully to the left. = Connect your microphones to the MIC/LINE inputs. = Turn the LEVEL controls ( 3 ) gradually clockwise to set the volume of your choice. Observe the CLIP LEDs while adusting the volume. Make sure they never shine constantly but only light up at peak levels. = Use the LINE OUT connector ( 6 ) to connect an (optional) second B1520DSP. + Never place a microphone directly in front of the loudspeaker owing to danger of feedback! [. . . ] § 7 Claim for damages Failure of BEHRINGER to provide proper warranty service shall not entitle the buyer to claim (consequential) damages. In no event shall the liability of BEHRINGER exceed the invoiced value of the product. * Customers in the European Union please contact BEHRINGER Germany Support for further details. Technical specifications and appearance are subject to change without notice. The information contained herein is correct at the time of printing. All trademarks (except BEHRINGER, the BEHRINGER logo, JUST LISTEN and EUROLIVE) mentioned belong to their respective owners and are not affiliated with BEHRINGER. [. . . ]