User manual BEHRINGER B215A

[. . . ] B212A/B215A User Manual A50-19713-00004 EUROLIVE EUROLIVE B212A/B215A Important Safety Instructions 14) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. * ! This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosure - voltage that may be sufficient to constitute a risk of shock. This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. Please read the manual. 15) 16) Unplug this apparatus during lightning storms or when unused for long periods of time. [. . . ] + Make sure that children cannot play unsupervised with the unit or its packaging. + Please ensure proper disposal of all packing materials. 1. 1. 2 Initial operation Ensure adequate air supply and to avoid overheating do not place the unit near radiators etc. + Blown fuses must be replaced by fuses of the correct rating!Please refer to the "Specifications" section for the applicable rating. For connection to the mains use the enclosed power cord with cold connector which complies with the relevant safety regulations. + Please make sure that all devices are properly grounded. For your own safety, never remove or disable the ground conductors from the devices or on the power cords. The unit must always be connected to the mains outlet with a protective grounding connection. 2. 1: Control elements and connections (B212A and B215A) {1} Use this 1/4" stereo jack to connect a signal source that has 1/4" output. {2} Use this XLR connector to connect a signal source that has XLR output. + Always use either the XLR or the 1/4" jack input, and use the LEVEL control {4} to adapt the input sensitivity. {3} The LINK OUTPUT is directly connected to the inputs of the B212A/B215A and carries the input signal with no processing applied. In this way, you can route the signal to the input of another device (for example, a second B212A/B215A). {4} To set the volume of the LINE or MIC signal, use the LEVEL control. The left half of the control range is for attenuating the LINE signal. The right half is for raising the level of the MIC signal. {5} The CLIP LED lights up when signal distortion occurs. Reduce the volume with the LEVEL control until the CLIP LED does not light up any more, or occasionally lights up at signal peaks. + We would like to draw your attention to the fact that extremely loud sound levels may damage your hearing as well as your headphones/loudspeakers. Turn the LEVEL control fully to the left before you switch on the unit. Be careful to select a suitable volume at all times. {6} The HIGH control adjusts the high-frequency range. [. . . ] = connection or operation of the unit in any way that does not comply with the technical or safety regulations applicable in the country where the product is used. = damage/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. Any repair or opening of the unit carried out by unauthorized personnel (user included) will void the warranty. If an inspection of the product by BEHRINGER shows that the defect in question is not covered by the warranty, 7. [. . . ]