User manual BEHRINGER BCD3000

[. . . ] B-CONTROL DEEJAY BCD3000 User Manual Version 1. 0 March 2007 B-CONTROL DEEJAY BCD3000 IMPORTANT SAFETY INSTRUCTIONS 1) Read these instructions. 5) Do not use this apparatus near water. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. [. . . ] PLAYBACK of this driver type is always stereo (channels 1-2). For this reason, the MASTER OUT connectors on the rear panel and the PHONES connector on the front panel always provide the same music signal. 4. 2: The ASIO window in the BCD3000 control panel This is where you adjust all parameters of the ASIO driver. The TRAKTOR 3 LE software uses ASIO as is the case with most professional music applications. You can only select one software button per field. In the field IN A (CH 1-2), you can select the input source to be routed to the computer on channels 1-2 (Record). In the MASTER OUT section, you can select the playback channels CH 1-2 or CH 3-4 for the main outputs (Playback). In the PHONES OUT field, you can select the playback channels CH 1-2 or CH 3-4 for the headphones connector (Playback). Use Driver Latency to adjust the latency in order to optimize your computer's performance. If you set the control to "low" this will optimize the response of your BCD3000, but also increase the processor workload. In extreme cases, this can lead to clicking and drop-outs in the audio signal. The "mid" position gives you a good compromise between processor workload and the response time of the BCD3000. A "high" latency ensures trouble-free performance even on slow computers. "Latency" is the time that elapses between an operator action on the BCD3000 (e. pressing the PLAY button) and the actual output of the audio signal from the OUT connectors. Latency depends on the system used and the processing speed of your computer. Typical latencies are in the milliseconds range (1 ms = one thousandth of a second). Most people cannot hear latencies below 10 ms. When audio signals are passing through a computer, it is impossible to achieve a 0-ms latency. 4. 4: The MIDI window in the BCD3000 control panel On the MIDI page no parameters can be set. It only informs you about the various MIDI modes, depending on the GLOBAL MODE selected: In STANDARD mode, the buttons are "toggle off", i. when you release a button after pressing, the MIDI command is set back to its original value (like when you release a key on a keyboard). [. . . ] The information contained herein is correct at the time of printing. All trademarks (except BEHRINGER, the BEHRINGER logo, JUST LISTEN and B-CONTROL) mentioned belong to their respective owners and are not affiliated with BEHRINGER. BEHRINGER accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph or statement contained herein. Colors and specifications may vary slightly from product. Products are sold through our authorized dealers only. [. . . ]