User manual BEHRINGER EUROGRAND

[. . . ] User manual A50-64639-00001 EG 818 0 EG2180 EUROGRAND Important Safety Instructions 1) Read these instructions. 5) Do not use this apparatus near water. 7) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. [. . . ] If you want to hear the previously recorded track, continue with step #2. + TIP: If the PLAY LED for one of the tracks lights up, this warns you that notes have already been recorded on this track. If you select this track again for recording (REC LED lights up red), the previous recording will be lost. 4) Select a sound in the SOUND SELECT section. You can also use a sound combination (see chapter 4. 1) for recording. 5) Switch on the acoustic metronome signal by pressing the METRONOME button, if you want to make a metronomebacked recording. 2) Press the REC button. The REC LED above the TRACK 1 or TRACK 2 button lights up. The dots on the display start flashing in the metronome tempo that has been set, thus indicating the beat. Now, the EUROGRAND is set to record mode. 12 Advanced operation EUROGRAND 5. 5. 3 Playing back pieces of music This section describes how to play back the music piece you have just recorded. 1) Press the TRACK 1 and TRACK 2 buttons until the green PLAY LED above the buttons lights up. This is to activate the tracks for recording. + The memory of the music sequencer can store up to 10, 000 notes. However, this number can decrease depending on how much pedaling information is stored. + You can quit record mode by pressing the REC button again. 3) Press the TRACK button of the track you want to record until the REC LED above the button lights up red. If you did a recording take before, the last track selected will be used for recording. Depending on which track is currently used, you will have to select the other track for recording. + You can only activate those tracks for playback which actually contain note information. 2) If you want to have a metronome-backed playback, press the METRONOME button to switch on the metronome. 3) + Tip: If you select a track for recording, which already contains note information, all previously recorded notes on this track will be erased!4) Select a sound in the SOUND SELECT section. You can also use a sound combination (see chapter 4. 1) for recording. Press the SELECT button in the TEMPO/EDIT MODE section until the TEMPO LED lights up, then use the two < > buttons to adjust the playback tempo. + You can play back a recording at its original tempo by pressing the two < > buttons at the same time. 4) 5) Switch on the acoustic metronome signal by pressing the METRONOME button, if you want to make a metronomebacked recording. Press the START/STOP button to play back the recording. The current meter is constantly shown in the display. 6) Start recording by pressing the START/STOP button or simply start playing on the keyboard. The current meter is constantly shown in the display. + During playback the two tracks can be switched on/off at any time. [. . . ] In no event shall the liability of BEHRINGER exceed the invoiced value of the product. * Customers in the European Union please contact BEHRINGER Germany Support for further details. § 5 Warranty regulations 1. Warranty services will be furnished only if the product is accompanied by a copy of the original retail dealer's invoice. Any product deemed eligible for repair or replacement under the terms of this warranty will be repaired or replaced. Technical specifications and appearance are subject to change without notice. The information contained herein is correct at the time of printing. [. . . ]