User manual BEHRINGER GDI21

[. . . ] OFF (A)X(IS) (close miking at the edge of a cone) is very similar to CENTER, but produces a smoother, softer sound with less upper mid-range content; perfect in combination with MODE position HOT. When activated, the GND LIFT disconnects the ground connection between input and output. Depending on the grounding of the connected equipment, this can eliminate hum or ground loops. Use the footswitch to activate/deactivate all the tone functions (EQ, DRIVE, modeling). [. . . ] Rounder and more evened-out (yet still sophisticated) sounds can be dialed up if you select CALIF(ORNIAN); its perfect for leads. Use the MODE switch to dial up one of three gain settings (HOT, HI G(AIN), CL(EA)N) that you want to combine with the amp setting. The serial number of the GDI21 is located on the bottom. Open the lid to install or replace the 9 V battery (see also chapter POWER REQUIREMENTS). The GDI21 is powered as soon you insert a plug into the INPUT. The battery is disconnected when the plug is removed. For this reason, the GDI21 has no on/off switch. To prolong battery life, always disconnect the input when the driver is not in use. + BEHRINGER V-TONE GUITAR GDI21 SAMPLE SETTINGS Power supply connector Use the DC IN connection to plug in a 9 V power supply (not included). For details please refer to chapter POWER REQUIREMENTS. APPLICATIONS Use with other instruments The GDI21 is not only for electric guitars. You can try it with other instruments (e. acoustic/bass guitars, keyboards etc. ) to create new sounds and enhance your music. Please make sure that the input level is not too high to avoid overloading the GDI21. Direct to a mixing console For live and studio applications you can connect the balanced XLR BAL OUT directly to a mic input of a mixing console. Be sure not to overload the input by using the gain control of the respective channel. For further information please refer to the users manual of your mixing console. Use without instruments You can use the GDI21 without an instrument as an outboard processor connected to an insert or an effect path (aux send/ return) of your mixing console to affect the signal of a particular channel. This way you can enhance existing tracks during mixdown. For further information please refer to the users manual of your mixing console. POWER REQUIREMENTS Battery: Utilizes standard 9 V alkaline battery (not included). 25 mA Power supply: ATTENTION: PLEASE USE DC POWER SUPPLY ONLY!Failure to do so may damage the unit and void the warranty. [. . . ] Products are sold through our authorised dealers only. Distributors and dealers are not agents of BEHRINGER® and have absolutely no authority to bind BEHRINGER® by any express or implied undertaking or representation. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording of any kind, for any purpose, without the express written permission of BEHRINGER Spezielle Studiotechnik GmbH. BEHRINGER® is a registered trademark. [. . . ]