User manual BEHRINGER MON800

[. . . ] MINIMON MON800 Users manual Version 1. 0 October 2005 DEUTSCH MINIMON MON800 IMPORTANT SAFETY INSTRUCTIONS CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. To reduce the risk of fire or electric shock, do not expose this appliance to rain and moisture. The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. [. . . ] Hold the button down as long as you wish to speak. The switch turns your MINIMON MON800 on and off. + + Attention: The switch does not fully disconnect the unit from the mains. To disconnect the unit from the mains, pull out the main cord plug or appliance coupler. When installing the product, ensure the plug or appliance coupler is readily operable. Unplug the power cord completely when the unit is not used for prolonged periods of time. 3. 2 Rear panel Fig. 3. 2: Rear panel connectors of the MON800 The MON800 is connected to the mains using a 2-pole POWER connector jack. A matching mains adaptor is included with the unit. + To avoid damage to your COM800 always use the mains adaptor supplied with the unit. A second pair of headphones can be connected to the PH jack. This connector is wired in parallel with the front-panel jack . CONTROL ELEMENTS AND CONNECTIONS DEUTSCH MINIMON MON800 The TB jack is used to connect a single footswitch. This footswitch allows hands-free talking and the use of the talk-back button (TALK TO CUE/PHONES/SPK A) at the same time. Hold the button down as long as you wish to speak. Two pairs of loudspeakers can be connected to the SPEAKERS OUT B and C jacks. Since the levels of both pairs (B and C) can only be adjusted together on the MON800, its a good idea to connect one speaker pair to output B and an additional sub-woofer to output C (see chapter 4. 1). + + Connect your main monitor speakers to the SPEAKERS OUT A jack. The loudspeaker outputs are designed for the connection of active systems or an external amplifier with passive speakers. CUE OUT is an additional output, which you can use to route the MINIMON signals to other devices, such as an additional headphones amp (e. g. BEHRINGER MINIAMP AMP800) (see chapter 4. 1). + The CUE OUT level cannot be changed on the MON800. The two 2-TRACK OUT jacks are wired in parallel and carry the same signals. Use the 1/4" or cinch outputs, depending on the recording device used. Use the CD/TAPE IN jacks C and D to connect playback devices, such as a computer, CD/MD or cassette player. The MIX IN jacks A and B are for connecting the main signal sources (e. g. mixing console, audio card, etc. ) using 1/4" plugs. [. . . ] Any repair or opening of the unit carried out by unauthorized personnel (user included) will void the warranty. If an inspection of the product by BEHRINGER shows that the defect in question is not covered by the warranty, the inspection costs are payable by the customer. Products which do not meet the terms of this warranty will be repaired exclusively at the buyers expense. BEHRINGER will inform the buyer of any such circumstance. [. . . ]