User manual BEHRINGER MX882

[. . . ] MX882 Users Manual Version 1. 2 März 2001 ULTRALINK PRO www. behringer. com ENGLISH ULTRALINK PRO MX882 SAFETY INSTRUCTIONS CAUTION: To reduce the risk of electrical shock, do not remove the cover (or back). No user serviceable parts inside; refer servicing to qualified personnel. WARNING: To reduce the risk of fire or electrical shock, do not expose this appliance to rain or moisture. This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosure - voltage that may be sufficient to constitute a risk of shock. This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. [. . . ] The MAIN OUTPUT LEVEL control adjusts the output level applied to the main outputs. The levels present at the six mono outputs are not affected. Summing the signal levels of several mono channels can overload the main output stage. The MAIN OUTPUT LEVEL control is therefore used to adjust the overall output level. The 4-digit OUTPUT LEVEL meter informs you about the output level of the main input within a range from -24 to +6 dB. This SPLIT/MIX switch sets the respective channel to SPLITTER or MIXER mode. The LEVEL control determines the signal level of the individual channels. In SPLIT mode, the LEVEL control sets the output level of the mono channels. In MIX mode, however, it controls the amount of the mono channel's input signal feeding into the main output section; at the same time, the level of the mono channel can be determined, whichowing to the maximum gain of +15 dBallows for converting, e. g. , home recording levels (-10 dBV) into studio levels (+4 dBu). The 8-digit OUTPUT LEVEL meter informs you about the output level of each channel within a range from -24 to +18 dB. 5 6 7 8 4. CONTROL ELEMENTS 9 ULTRALINK PRO MX882 9 With the BALANCE/PAN control you can set the balance between the left and right main signals. In SPLIT mode, the main input signal is routed to the mono output, with the BALANCE control determining the balance beween the left and right main signal portions. In MIX mode, the mono inputs are mixed and routed via the LEVEL control to the main outputs, with the PAN controls determining the allocation of the mono inputs to the left and right main outputs. 4. 2 The rear panel elements Fig. 4. 3: Rear panel elements 10 FUSE HOLDER / VOLTAGE SELECTOR. Please make sure that your local voltage matches the voltage indicated on the unit, before you attempt to connect and operate the ULTRALINK PRO. Blown fuses may only be replaced by fuses of the same type and rating. Use the enclosed power cord to connect the unit to the mains. Please also note the instructions given in chapter 3 INSTALLATION . These are the main audio inputs of your ULTRALINK PRO, available as balanced XLR connectors. They may feed the mono outputs of all channels which are operated in SPLIT mode. These are the main outputs, available as balanced XLR connectors. They may be fed either by the left and right main inputs or by any of the six mono inputs (or a combination of both). [. . . ] Free inspections and maintenance/repair work are expressly excluded from this warranty, in particular, if caused by improper handling of the product by the user. This also applies to defects caused by normal wear and tear, in particular, of faders, potentiometers, keys/buttons and similar parts. Damages/defects caused by the following conditions are not covered by this warranty: s misuse, neglect or failure to operate the unit in compliance with the instructions given in BEHRINGER user or service manuals. s connection or operation of the unit in any way that does not comply with the technical or safety regulations applicable in the country where the product is used. [. . . ]