User manual BEHRINGER PMP518M

[. . . ] PMP518M User Manual Version 1. 0 February 2007 EUROPOWER EUROPOWER PMP518M IMPORTANT SAFETY INSTRUCTIONS 14) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. 15) Unplug this apparatus during lightning storms or when unused for long periods of time. 16) Refer all servicing to qualified service personnel. [. . . ] The LEVEL control adjusts the channel signal level in the main mix. The CLIP LED is very useful to control the input gain. It should never be constantly illuminated (only with signal peaks). The PAD switch reduces the input sensitivity of the channel by approx. 30 dB, to connect for example line-level signals. The balanced LINE IN input (1/4" TRS) can be used for line-level signal sources, e. g. Each channel has a balanced MIC microphone input with XLR connectors. Unplug the power cord completely when the unit is not used for prolonged periods of time. + 2. 2 Effects section Be sure that the CLIP LED illuminates for signal peaks only. If it is illuminated all the time, it is a sign that the effects processor is overloading and hence producing unpleasant distortion. The SIG LED below illuminates when the effects processor receives an input signal. The EFFECT display shows the currently selected preset. Turn the PROGRAM control to select an effects preset (preset number starts flashing). Push the control briefly to confirm your selection. Press the FX IN button to activate the effects processor. + + 6 2. CONTROL ELEMENTS EUROPOWER PMP518M Fig. 2. 2: Rear panel control elements and connectors 2. 4 Rear panel The mains connection is on a standard IEC receptacle. An appropriate power cord is supplied with the unit. Before connecting the unit to the mains, ensure that the voltage setting matches your local voltage. Blown fuses should only be replaced by fuses of the same type and rating. Please also read the information given in chapter 6 SPECIFICATIONS. The three PARALLEL SPEAKER OUTPUTs provide the mono main signal on a Neutrik Speakon-compatible connector (pins 1+/1- and 2+/2-) and on two 1/4" TS connectors. The impedance of the loudspeaker connected must not fall below 4 W. [. . . ] This also applies to defects caused by normal wear and tear, in particular, of faders, crossfaders, potentiometers, keys/buttons, tubes, guitar strings, illuminants and similar parts. Damages/defects caused by the following conditions are not covered by this warranty: s improper handling, neglect or failure to operate the unit in compliance with the instructions given in BEHRINGER user or service manuals. connection or operation of the unit in any way that does not comply with the technical or safety regulations applicable in the country where the product is used. damages/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. s s 5. [. . . ]