User manual BEHRINGER SO400

[. . . ] CONTROLS Top view The MODE switch selects one of the following operation modes: POLY: Single octave sound which allows to play treble tones without effect over bass tones with octave effect. OCT 2: Heavy octave sound, adds a second octave to the first one. DRIVE: Adds an overdrive effect to the original and the octaved signal. The DIRECT control adjusts the level of the original input signal (and the DIR OUT connector). [. . . ] When the effect is active, the effects signal is sent through OUT A while the DIR OUT carries the input signal. The volume of the DIR OUT signal is depending on the DIRECT control's setting. This output configuration is useful when different effects should be added to the input signal and the effect signal, after the octave pedal's output. If the DIR OUT connector is not in use, the unaffected input signal and the effect signal are both sent out through OUT A, depending on the effect activation. Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included). The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to scratch the unit. SUPER OCTAVER SO400 The SO400 has no On/Off switch. It is operable as soon as you insert a plug into one of the IN connectors. Disconnect the plug, if you don't use the SO400. In doing so, you can extend the life time of the battery. The SERIAL NUMBER is located at the underside. In rare cases interferences of the normal function may appear by external influence (e. g. electrostatic discharge), as for example sound disturbances or malfunctions. If this occurs, please turn down the volume on subsequent amplifiers and disconnect the input connector briefly to restart the application. 2. WARRANTY For our current warranty terms, please refer to our website at http://www. behringer. com. 3. SPECIFICATIONS GTR IN / BASS IN DIR OUT / OUT A Power supply BEHRINGER PSU-SB Connector 1/4" TS Impedance 500 k Connector 1/4" TS Impedance 1 k 9 V_, 100 mA regulated USA/Canada 120 V~, 60 Hz China/Korea 220 V~, 50 Hz Europe/U. K. /Australia 230 V~, 50 Hz Japan 100 V~, 50 - 60 Hz Export model 120/230 V~, 50 - 60 Hz 2 mm DC jack, negative center 9 V type 6LR61 60 mA approx. 54 mm (2 1/8") x 70 mm (2 3/4") x 123 mm (4 4/5") approx. 0. 33 kg (0. 73 lbs) Power connector Battery Power consumption Dimensions (H x W x D) Weight BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these efforts, modifications may be made from time to time to existing products without prior notice. [. . . ] Products are sold through our authorized dealers only. Distributors and dealers are not agents of BEHRINGER and have absolutely no authority to bind BEHRINGER by any express or implied undertaking or representation. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording of any kind, for any purpose, without the express written permission of BEHRINGER International GmbH. © 2007 BEHRINGER International GmbH. [. . . ]