User manual BEHRINGER UBB1002

[. . . ] UBB1002 Users Manual Version 1. 0 November 2002 EURORACK www. behringer. com ENGLISH EURORACK UBB1002 SAFETY INSTRUCTIONS DETAILED SAFETY INSTRUCTIONS: All the safety and operation instructions should be read before the appliance is operated. Retain Instructions: The safety and operating instructions should be retained for future reference. Heed Warnings: All warnings on the appliance and in the operating instructions should be adhered to. CAUTION: To reduce the risk of electric shock, do not remove the cover (or rear). [. . . ] The stereo channels 3/4, 5/6, and 7/8 differ from channels 1 and 2 not only with regard to the connectors provided. you can connect a microphone and a stereo line signal at the same time! + The phantom power required for condenser mics + can be activated with switch . Please note that in battery-operated mode the phantom power provided is only +18 V!Channels 1 and 2 feature an additional LINE input on a balanced 1/4" jack. The INSERT jack allows you to insert, for example, a compressor or equalizer in the mono channels. These are the two balanced LINE inputs on 1/4" jacks for the left and right sides of the stereo channels, which can be used in parallel to the microphone inputs. Use the TAPE OUT jacks to connect, for example, a tape deck for recording applications. The TAPE IN jacks (on stereo RCA and 1/4" jacks) allow for the connection of play-back devices such as CD players, etc. Use either the RCA or the 1/4" jacks. Use the PHONES jack to connect a commercially available pair of headphones. These are the balanced 1/4" jack MAIN OUTPUTS of your UBB1002 that can be used to drive, e. g. The MON SEND connector provides the monitor signal of your UBB1002, for example, to control a monitor amplifier or active monitor speaker. Connect the FX SEND connector to the input of an external effects device. The UBB1002 has no dedicated FX Return connectors. However, you can connect the outputs of an external effects device to the 1/4" jack inputs of the stereo channels or channels 9/10. In this case, the stereo channels FX control must be set to -oo to avoid any feedback problems. When you connect a microphone to a stereo channel on the UBB1002, the input gain is governed by the GAIN MIC control!The GAIN LINE control is used to adjust the line input gain. Here, too, the signal can be monitored visually with the Clip LED. The BAL control performs two functions: When you connect a microphone via the XLR connector, or another signal source via the L/MONO jack, the BAL control determines the signal position on the stereo basis. When both 1/4" jack inputs (L & R) are used, the BAL control adjusts the volume balance of the two sources connected. Except for the GAIN MIC control and a different set of connectors, the channels 9/10 feature the same control elements as the stereo channels. See & and through . 1. 3. 3 Main section The LEVEL DISPLAY reads the output level of your UBB1002. Make sure that the two Clip LEDs wont light up. [. . . ] Damages/defects caused by the following conditions are not covered by this warranty: s improper handling, neglect or failure to operate the unit in compliance with the instructions given in BEHRINGER user or service manuals. s connection or operation of the unit in any way that does not comply with the technical or safety regulations applicable in the country where the product is used. s damages/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. Any repair or opening of the unit carried out by unauthorized personnel (user included) will void the warranty. [. . . ]