User manual BEHRINGER UMA25S

[. . . ] UMA25S User Manual A50-50233-00001 U-CONTROL U-CONTROL UMA25S Important safety instructions 10) Place the power cord so that it is protected from being walked on and sharp edges. Be sure that the power cord is protected particularly at plugs, convenience receptacles and the point where it exits from the apparatus. 11) The apparatus shall be connected to a MAINS socket outlet with a protective earthing connection. 12) Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. [. . . ] These functions are also preserved after the device is switched off and can be activated at all times by simply pressing the MMC push button. This means that the push buttons E1 ­ E8 can each share two functions: first, the function assigned within a preset, and second, the assigned function that coincides with presets as soon as the MMC push button is activated. Assigning the 8 push buttons is described in Chapter 5. 4. You simply have to press the MMC push button (LED lights up) before activating Edit Mode. 6. 5. 3 Assignment of control elements using the Learn function The easiest way to assign MIDI functions to individual control elements is to use the Learn function over remote assignment. For example, MIDI data sent from a MIDI sequencer to your U-CONTROL are assigned to a control element in advance. Not only CC, NRPN and Note messages can be received with the Learn function, but almost any type of MIDI data including short SysEx strings. Press and hold down the EDIT/EXIT push button. Operate the control element that is supposed to learn the MIDI function. "Lrn" appears on the display while the MIDI device waits for an external MIDI message. Transmit the MIDI message to the UMA25S from the device you want to control. If valid MIDI data are received, the display shows "Gd!" (good). If invalid, incorrect or too long, "Err" (error) appears on the display. Alternatively, press the EDIT/EXIT push button to cancel the changes made. 7a. 7b. The device switches to Play Mode (EDIT LED goes out). All settings made with this function are stored temporarily!If you want to store the settings permanently, save them in a preset (see Chapter 5. 1. 2). 5. UMA25S as USB/MIDI controller 13 U-CONTROL UMA25S E9 E10 E11 E12 E13 E14 E15 E16 Example of the Learn function: In order to control the main volume level of a virtual instrument with the E19 slider, follow the steps below: 1. Press and hold the EDIT/EXIT push button. Now move the volume control of the software instrument with your computer's mouse. When "Gd!" appears on the display, press the ENTER key. To save these settings, store them in a preset. MIDI MIDI Value Value Controller Controller Display Data Send Parameter 1 2 Mode Option Value Type Channel Table 5. 1: General assingment of rotary knobs in Edit Mode MIDI Data Type: The E9 rotary knob lets you select the message type that is to be assigned to a control element. [. . . ] Products which do not meet the terms of this warranty will be repaired exclusively at the buyer's expense. BEHRINGER will inform the buyer of any such circumstance. If the buyer fails to submit a written repair order within 6 weeks after notification, BEHRINGER will return the unit. Costs for freight and packing will be invoiced separately C. O. D. [. . . ]