User manual BEHRINGER UP1000

[. . . ] When a cart is used, use caution when moving the cart/device combination to avoid injury from stumbling over it. 13) Unplug this device during lightning storms or when not used for long periods of time. 14) Refer all servicing to qualified service personnel. Servicing is required when the unit has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the device, the unit has been exposed to rain or moisture, does not operate normally, or has been dropped. 15) The spotlight has not been designed for outdoor use, and should be used in dry rooms only, with a humidity below 90%. [. . . ] LENSES 5 ULTRAPAR UP1000 3. 1 Dismounting the lens The lens gets very hot during operation of the spotlight, so let it cool down sufficiently before you attempt to dismount it! + s Disconnect the spotlight from the mains and wait until it has cooled down. s Place the spotlight on a flat and stable surface. Never mount or dismount the lens, while the spotlight is fixed to a truss or stand. s Remove the protective mesh : press its two spring shackles, then pull out the mesh. attached to the s Directly in front of the lens, you will find a movable metal clamp . Turn the lens ring, until the metal clamp is located on the top side of the spotlight lens ring (directly below the locking bracket ). s Tilt the front side of the spotlight forward by at least 45°. s Push the movable metal clamp upward to dismount and pull out the lens . 3. 2 Mounting the lens is located s Tilt the spotlight forward and turn the lens ring , until the movable metal clamp on the top side of the spotlight (directly below the locking bracket ). s Insert the lens with its rounded side towards the rear. The lower edge of the lens must be located behind the projecting elements of the lens ring. s Press the upper edge of the lens slightly towards the rear, until it locks in behind the metal clamp . s Installation of the protective mesh : Press the two spring shackles of the protective mesh and place it directly in front of the lens ring . There are two slots in the die-cast casing of your ULTRAPAR for the feet of the protective mesh. The two spring shackles must be located directly below the locking bracket . 4. COLOR FRAME is used to hold color filters. Please observe the following instructions to install The color frame the color frame: s Detach the locking bracket on the top side of the spotlight, by pushing it to the side. Then, open the bracket and tilt it towards the rear. s Insert the color frame into the frame holders and on three sides) on the front side of the ULTRAPAR. the outer guiding rail (with stops to the side and move it down until it locks in. + + 6 Only use color filters with appropriate temperature resistance!Never use your ULTRAPAR without the protective mesh in combination with the color frame because it prevents direct contact with the hot lamp surface. It also prevents pieces of broken glass from uncontrollably dispersing in the event of the lens being broken. CLEANING THE REFLECTOR s Disconnect the spotlight from the mains and remove the lamp casing as described in chapter 2. 1. s Remove the color frame (chapter 4), the protective mesh and lens the reflector is easily accessible. (chapter 3. 1), so that s Cleaning the reflector: Use oil-free compressed air or a soft, lint-free cotton cloth. Tenacious stains can be removed by adding some mild soap water, however, dont forget to remove all soap water remnants as well! [. . . ] § 7 OTHER WARRANTY RIGHTS AND NATIONAL LAW 1. This warranty does not exclude or limit the buyers statutory rights provided by national law, in particular, any such rights against the seller that arise from a legally effective purchase contract. The warranty regulations mentioned herein are applicable unless they constitute an infringement of national warranty law. * Customers in the European Union please contact BEHRINGER Germany Support for further details. The information contained in this manual is subject to change without notice. [. . . ]