User manual BEHRINGER US600

[. . . ] The HR KEY control is used in HARMONIST mode to determine the key you are playing in. This assures that the right notes fitting with the harmonic preconditions are generated by the effect. You can select out of 10 different keys: 1. F major (D minor) The PITCH control adjusts the amount of pitch shifting. [. . . ] The effect is only active when you keep the footswitch depressed. The ON/BATT LED illuminates when the effect is activated. Use the footswitch to activate/deactivate the effect. Use this 1/4" TS IN connector to plug in the instrument cable. The two 1/4" TS OUT A and OUT B connectors send the signal to your amp. If both outputs are used they will output different signals in the modes PITCH SHIFTER, HARMONIST and DETUNE. OUT A will have the pitch shifted signal while OUT B will have the input signal. The volume of both outputs will be effected by the BALANCE control. In TREM BAR and FLUTTER mode both outputs will have the pitch shifted signal. ULTRA SHIFTER/HARMONIST US600 Use the 1/4" TRS EXP/CTL connector to connect an expression pedal. Set the pedal to the lowest position when connecting it to the unit. Then push it to the forward position and choose the desired pitch value with the PITCH control. Now you can control the pitch value of the effect within the range defined by the PITCH control (low position = no pitch shift, forward position = maximum pitch shift). Use the DC IN connection to plug in a 9 V power supply (not included). The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove the pedal cover. As soon as you insert the plug into the IN connector, the US600 begins running. When not using the US600, remove the plug from the IN connector. The SERIAL NUMBER is located on the underside. + In rare cases interferences of the normal function may appear by external influence (e. g. electrostatic discharge), as for example sound disturbances or malfunctions. If this occurs, please turn down the volume on subsequent amplifiers and disconnect the input connector briefly to restart the application. 2. Warranty For our current warranty terms, please refer to our website at http://www. behringer. com. 3. [. . . ] The information contained herein is correct at the time of printing. BEHRINGER accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph or statement contained herein. Colours and specification may vary slightly from product. Products are sold through our authorised dealers only. [. . . ]