User manual BEHRINGER XL1600

[. . . ] XL1600/XL2400/XL3200 User Manual A50-77230-08001 XENYX XENYX XL1600/XL2400/XL3200 Important Safety Instructions 1) Read these instructions. 5) Do not use this apparatus near water. This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosure - voltage that may be sufficient to constitute a risk of shock. This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. [. . . ] Toggle the EQ to give you a quick comparison between unprocessed and processed signal. 10 Control elements XENYX XL1600/XL2400/XL3200 5. 1. 2 Channel fader, pan control, mute control, etc. PAN The PAN control determines the position of the channel signal in the stereo mix as well as the subgroup to which the channel signal is routed. This means that the channel signal has been removed from the main mix and subgroups. At the same time the FX, monitor and aux paths of the respective channel are muted as well. The corresponding MUTE LED indicates that the channel has been muted. SOLO Use the solo function to listen in on a channel. Press the channel's SOLO switch to hear the signal on your headphones. Simultaneously, the monitor meter 1/2 switches to the solo signal, allowing you to level the signal correctly (see chapter X). The signal to be listened in on is tapped either before (PFL, mono) or behind (AFL, stereo) the channel fader and the pan control (depending on the state of the PFL/AFL switch. The corresponding LED lights up when the solo function is activated. CLIP The CLIP LED lights up as soon as the channel's level is too high. In this case, reduce the channel's input amplification with the TRIM control. SIG The SIG LED lights up when a channel's signal is higher than -20 dB. The signals are indicated even when the fader is pulled down and the channel is muted. Fader The channel fader adjusts the level of the channel signal as part of the main mix (or submix). 1-2, 3-4, MIX The routing switch routes the signal to the respective subgroup or the main mix or both. The PAN control determines the group to which the signal is routed (fully left: Sub 1 or 3, fully right: Sub 2 or 4). 5. 2. 1 Equalizer stereo channels The stereo channels provide 4-band equalization. Each frequency band can be boosted and cut up to 15 dB and has a flat response when the controls are in center position. HIGH The HIGH control of the EQ section adjusts the high-frequency range of the respective channel. This is a shelving filter which boosts and cuts the frequencies above 12 kHz. HIGH MID The HIGH MID control adjusts the mid frequency range. This is a peak filter which boosts and cuts the frequencies centered at 3 kHz. LOW MID The LOW MID control adjusts the mid frequency range. [. . . ] § 6 Warranty transferability This warranty is extended exclusively to the original buyer (customer of retail dealer) and is not transferable to anyone who may subsequently purchase this product. No other person (retail dealer, etc. ) shall be entitled to give any warranty promise on behalf of BEHRINGER. § 7 Claim for damages Failure of BEHRINGER to provide proper warranty service shall not entitle the buyer to claim (consequential) damages. In no event shall the liability of BEHRINGER exceed the invoiced value of the product. [. . . ]