User manual BEKO 28422VND/S

[. . . ] G) This appliance is not intended for use by young children or infirm persons without supervision H) Young children should be supervised to ensure they do not play with the appliance I) There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels L) There is a risk of fire if cleaning is not carried out Assembly and electrical connections must be carried out by specialised personnel. Electric Connection The appliance has been manufactured as a class II, therefore no earth cable is necessary. The connection to the mains is carried out as follows: BROWN = L line BLUE = N neutral If not provided, connect a plug for the electrical load indicated on the description label. Where a plug is provided, the cooker hood must be installed in order that the plug is easily accessible. [. . . ] - Place the appliance against the wall, align it in horizontal position and tighten screws K (Fig. - Once the adjustment has been completed, fix the hood using the 2 screws C (Fig. - When carrying out the fixing operations, use only screws and screw anchors suited to the type of wall (e. - If the screws and screw anchors are supplied with the appliance, make sure that they are suited to the type of wall to which the hood must be fixed. - Fix the lid once again by using the 4 screws previously removed in (Fig. OPTIONAL ACCESSORIES This model may have decorative ducts as optional accessories - ask your retailer for information. Before fixing the decorative ducts, remove both the 4 screws B and lid M, as shown in (Fig. A sound-absorbing kit is also available (to be ordered as an OPTIONAL accessory) in order to increase the quietness level of the hood. The sound-absorbing layer must be applied to the back of the decorative panel. INSTALLATION OF MODELS WITH DECORATIVE DUCTS Make sure the electrical power supply is within the measurements of the decorative connector. Then fix it to the ceiling so that it is on the same axis as the hood using screws A (Fig. replace the bulbs with new ones of the same type. Caution: do not touch the light bulb with bare hands. If the cooker hood is at speed level 1 it will not be necessary to depress the push-button to switch the cooker hood off. Touching the key at 3rd speed, the intensive function runs for 10', then the appliance go back to work at the original speed. During this function the display blinks. Key E = The Timer times the functions on activation for 15 minutes, after which they are switched off. the Timer is deactivated by re-pressing Key E. When the Timer is activated the decimal point must flash on the display. The Timer cannot be activated if the intensive speed is functioning. The "clean air" function is activated by pressing key E for 2 seconds when the appliance is switched off. This switches the motor on for 10 minutes every hour at the first speed. [. . . ] After ten minutes the motor switches off and the LED of key F remains switched on with a fixed light until the motor starts up again at the first speed after fifty minutes and keys F and C start to flash again for ten minutes and so on. By pressing any key for the exclusion of the hood light the hood will return immediately to its normal functioning (e. If key D is pressed the "clean air" function is deactivated and the motor moves to the 2nd speed straight away. by pressing key B the function is deactivated). [. . . ]