User manual BEKO 4401

[. . . ] Before plugging in the appliance, let it rest at least 12 hours. If these instructions are not complied with, can result in the motorcompressor failurem and the appliance could be took out from the guarantee. Safety measures and general advice If you observed any failure please do not put the appliance into operation. Do not leave the dors open more than it is necessary to take out and to put inside the food. [. . . ] These instructions contain important information regarding to the installation, using and maintenance of the appliance. The manufacturer will not be responsible if these instructions are not accordingly complied with the manual. Keep this manual into a safe place in order to easy consult it if necessary. Furthermore, it could be useful for another user. It is not recommended to stop the appliance if you will not use it for a few days. If you don't use it for a longer period, please proceed as follows: - unplug the appliance; - empty the refrigerator and the freezer; - defrost and clean the appliance; - let the doors open in order to avoid the unpleasant odors. The supply cord can be replaced only by an authorised person. Any "suspended" furniture will be assembled at a minimum distance of 10 cm above the appliance. The same distance will be also provided in case of a niche or another construction element. The appliance is not made to be built in the furniture. Your appliance is designed to work at a mono-phase voltage of 220-240V, 50Hz. Avoid some positions of thermostat button that could involve a continuously running of the appliance. It is not necessary any intervention from you. the resulted water is collected in a drip pan located on the compressor. The water evaporates there because of the heat issued during its working (Item 5). Keep clean the collector and draining hose for the water flow resulted after defrosting. to do so , use the supplied trench part. Check the hose to be permanently with the end inside the drip tray on the compressor in order to prevent the water flow above the electric wiring or on the floor. We recommend that you switch off the appliance at the socket outlet and pull out the mains plug before cleaning. Never use any sharp instruments or abrasive substances, soap, househould cleaner, detergent or wax polish for cleaning. Use luke warm water to clean the cabinet of the appliance and wipe it dry. Use a damp cloth wrung out in a solution of one teaspoon of bicarbonate of soda to one pint of water to clean the intreior and wipe it dry. [. . . ] Unplug the appliance, take out the lamp and replace it with another and assemble. The appliance is too noisy The appliance was not installed properly. The back pipes are touching or vibrating. There is a contact between the bottles or other vessels inside. [. . . ]