User manual BEKO BCN 130000

[. . . ] Dear Customer, We hope that your product, which has been produced in modern plants and Checked under the most meticulous quality control procedures, will provide you an effective service. Therefore, read this entire user manual carefully before using the product and keep it as a reference. If you handover the product to someone else, give the user manual as well. The user manual will help you use the product in a fast and safe way. [. . . ] Before you start the refrigerator, Check the following before you start to use your refrigerator: Plastic wedges are intended to keep the distance which will ensure the air circulation between your refrigerator and the wall. (The picture is drawn up as a representation and it is not identical with your product. Clean the interior of the refrigerator as recommended in the "Maintenance and cleaning" section. Connect the plug of the refrigerator to the wall socket. When the fridge door is opened, fridge internal lamp will turn on. When the compressor starts to operate, a sound will be heard. The liquid and gases sealed within the refrigeration system may also give rise to noise, even if the compressor is not running and this is quite normal. Front edges of the refrigerator may feel warm. These areas are designed to be warm to avoid condensation. Do not place your product on the materials such as rug or carpet. Place your refrigerator on an even floor surface to prevent jolts. changing the illumination lamp To change the Bulb/LED used for illumination of your refrigerator, call your AuthorisedService. The lamp(s) used in this appliance is not suitable for household room illumination. The intended purpose of this lamp is to assist the user to place foodstuffs in the refrigerator/freezer in a safe and comfortable way. The lamps used in this appliance have to withstand extreme physical conditions such as temperatures below -20 °C. *May not be available in all models An audio warning signal will be given When the door of your product is left open for at least 1 minute. This warning will be muted when the door is closed or any of the display buttons (if any) are pressed. Your cooler/freezer should be installed at least 30 cm away from heat sources such as hobs, ovens, central heater and stoves and at least 5 cm away from electrical ovens and should not be located under direct sunlight. The ambient temperature of the room where you install your cooler/freezer should at least be 10°C. Operating your cooler/freezer under cooler conditions is not recommended with regard to its efficiency. Please make sure that the interior of your cooler/freezer is cleaned thoroughly. If two cooler/freezers are to be installed side by side, there should be at least 2 cm distance between them. [. . . ] >>> If The product is shaking when moved slowly, adjust the stands to balance the product. Also make sure the ground is sufficiently durable to bear the product. Any items placed on the product may cause noise. >>> Remove any items placed on the product. [. . . ]