User manual BEKO CDA565F

[. . . ] Frost Free Combi Fridge / Freezer CDA 565 FW CDA 565 FS BEKO plc Beko House Caxton Way Watford Hertfordshire WD18 8UF Tel: 0845 6004911 Fax: 0845 6004922 e-mail: service@beko. co. uk website: www. beko. co. uk Printed in Turkey Part no: 48 6378 0004 Congratulations on your choice of a service for many years. quality Appliance which has been designed to give you CONTENTS SAFETY FIRST / ELECTRICAL REQUIREMENTS TRANSPORTATION INSTRUCTIONS INSTALLATION INSTRUCTIONS GETTING TO KNOW YOUR BEKO FRIDGE / FREEZER REVERSING THE DOORS SUGGESTED ARRANGEMENT OF FOOD IN THE FRIDGE / FREEZER TEMPERATURE CONTROL AND ADJUSTMENT STARTING STORING FROZEN FOOD FREEZING FRESH FOOD MAKING ICE CUBES DEFROSTING CLEANING AND CARE PAGE 3 4 4-5 6 7-8 9 10 11 11 12 12 13 14 14 15 16 17 17 18 19 WARNING !DO NOT connect your appliance to the electricity supply until all packing and transit protectors have been removed. · Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally. · If you are discarding an old refrigerator with a lock or latch fitted to the door, disable the lock/latch, ensure that it is left in a safe condition to prevent the entrapment of young children. [. . . ] Therefore never leave the door open and ensure it is closed immediately after food is put in or removed. If the ambient (room or garage) temperature is between 0 °C and -15 °C, we recommend you adjust the knob to setting 4 to reach -18 C in the freezer compartment. Lower temperatures may be obtained by adjusting setting knob towards max position. 10 STARTING Final Check Before you start using the fridge/freezer check that: 1. The feet have been adjusted for perfect levelling. The interior is dry and air can circulate freely at the rear of the cabinet. Clean the interior as recommended under "CLEANING AND CARE. " Insert the plug into the wall socket and switch on the electricity supply. · When the door is open the fridge interior light will come on. You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also give rise to noise, whether the compressor is running or not which is quite normal. "Due to operation of the fan inside the frost free freezer compartment, overall noise level is slightly higher in comparison to non-frost free appliances. This is quite normal and is not a fault. " Set the setting knob half way between min and max. Front edges of the cabinet may feel warm. These areas are designed to be warm to avoid condensation. "Do not load the appliance immediately it is switched on. Wait until the correct storage temperature has been reached. We recommend that you check the temperature with an accurate thermometer (see; Temperature Control and Adjustment)" When the freezer reaches the desired temperature the freezer fan will stop. When the freezer fan is on, the noise will be louder when the freezer door is opened. Avoid spillage of food particularly small items like rice, peas, beans through the fan guard as they may cause the cooling system to block and therefore operate less efficiently. FREEZING FRESH FOOD Please observe the following instructions to obtain the best results. Do not freeze too large a quantity at any one time. The quality of the food is best preserved when it is frozen right through to the core as quickly as possible. Do not exceed the freezing capacity of your appliance in 24 h which is 4 kg (8. 8 lb) Placing warm food into the freezer compartment causes the refrigeration compressor to operate continuously until the food is frozen solid. This can temporarily lead to excessive cooling of the refrigeration compartment. [. . . ] (Food loss insurance is often included within your household contents insurance policy, or may be available separately from your retailer). · Your Beko product is designed and built for domestic household use only. · The guarantee will be void if the product is installed or used in commercial or non-residential domestic household premises. · The product must be correctly installed, located and operated in accordance with the instructions contained in the User Instructions Booklet provided. [. . . ]