User manual BEKO CFB6433

[. . . ] Take them to the packaging material collection points designated by the local authorities. This product was manufactured using the latest technology in environmentally friendly conditions. The Instructions for Use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. [. . . ] Take it to the collection center for the recycling of electrical and electronic equipment. Please consult your local authorities to learn about these collection centers. The product you have purchased complies with EU RoHS Directive (2011/65/EU). It does not contain harmful and prohibited materials specified in the Directive. Package of the product is made of recyclable materials in accordance with our National Legislation. Do not dispose of the packaging materials together with the domestic or other wastes. Take them to the packaging material collection points designated by the local authorities. 1 When used in the extraction Mode, the cooker hood ducting must not be connected to a flue which is used for exhausting fumes from appliances supplied with energy other than electric, such as a central heating flue or water heating flue. During winter supply ensure that the mains Time it may be convenient to use voltage corresponds with the The hood in the recycling mode to voltage on the rating plate Avoid heat loss from the kitchen. 3 Connect the cooker hood to the Consideration should be given to mains via a double poled switch The difficulties that can be found during installation. Which has 3mm clearance between the contacts. Work must be undertaken by a qualified and competent person in conformity to the rules concerning the evacuation of contaminated air. The manufacturer disclaims all liability for any damage or injury caused as a result of not following the instructions for installation contained in the following text. 4 For cooker hoods featuring an earth cable, make sure the electric plant of your house is correctly earthed. 5 Appliance in class II are provided with a double insulation; therefore do not connect them through earthed plugs but through a double poled plugs. 6 When installed, the hood must It must be replaced by a special From the manufacturer or its Disconnect the hood from the 10 If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then this must be of the room Knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. To ensure that they do not play Are fitted, ensure that there is Hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the Room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by 11 The appliance must be positioned so that the plug is accessible. Some installation systems require the opening and removal of the metal grille panel. 1 Instructions for opening and removing the metal grille panel To open the grille panel, press inwardly on the two slider catches at each side of the grille panel and the grille will pivot down. To remove the metal grille, pull forward on the right hand side so that the hinge pin on the back of the grille will be released from the slot in the side of the casing. Predrilled wall cabinet: fix the hood onto the wall cabinet base panel using the four screws 4. 2 x 45 mm (supplied with the fixing kit). [. . . ] It should be washed once a month in hot water using mild detergent or liquid soap. It should not be bent and should be left to drain dry. WARNING: An excess of grease in the filter not only would affect the a performance of the hood , but it is also a possible fire risk. We strongly recommend therefore to clean and replace filters in accordance with the manufacturer instructions. [. . . ]