User manual BEKO CGA963

[. . . ] C) Flambè cooking is prohibited underneath the cooker hood D) Avoid free flame, as it is damaging for the filters and a fire hazard E) Constantly check food frying to avoid that the overheated oil may become a fire hazard F) Disconnec t the elec trical plug prior to any maintenance. G) This appliance is not intended for use by young children or infirm persons without supervision H) Young children should be supervised to ensure they do not play with the appliance I) There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels L) There is a risk of fire if cleaning is not carried out in accordance with the instructions This appliance conforms to the European Directive EC/2002/96, Waste Electrical and Electronic Equipment (WEEE). Assembly and electrical connections must be carried out by specialised personnel. Electric Connection Note: Verify the data label placed inside the appliance: - If the symbol ( ) appears on the plate, it means that no earth connection must be made on the appliance, therefore follow the instructions concerning insulation class II. [. . . ] Make 4, Ø8 holes in the ceiling and drive in 3 screws without completely tightening them. Pay attention not to insert the screw into the hole marked with an X on the hole template (the screws and expansion plugs must be suitable for the type of wall). - Take the upper part of the structure B (Fig. 4) and insert the 3 slots onto the 3 screws that are not completely tightened. Drive in the fourth screw X and tighten the remaining 3 to allow definitive blocking of the upper part of structure B - Take the lower part of the telescopic structure C and insert it into the upper structure B (Fig. 15) and block it using the 8 screws G that are supplied (Fig. Suction version: fix the flexible pipe to the prepared air evacuation hole (Fig 7). Filtering version: We have two different types of Kit, one with extractable carbon filters (Fig. 18) and the other one with re-usable carbon filters (washable). 20 included in the product packaging, this should be fixed to the hood using the supplied screws. - Fix the flexible pipe to the deflector M and fix screw I as indicated in (Fig. Extended use of the light reduces the average duration of the bulb. To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. replace the bulbs with new ones of the same type. Caution: do not touch the light bulb with bare hands. In order to replace the dichroic lamps, carefully remove the lamp from the lamp holder with the help of a small flat screwdriver or a similar tool. In doing this operation, please take care If the cooker hood is at speed level 1 it will not be necessary to depress the push-button to switch the cooker hood off. Touching the key at 3rd speed, the intensive function runs for 10', then the appliance go back to work at the original speed. during this function the display blinks. Key E = The Timer times the functions on activation for 15 minutes, after which they are switched off. the Timer is deactivated by re-pressing Key E. When the Timer is activated the decimal point must flash on the display. [. . . ] By pressing key F for two seconds (with the hood switched off ) the "clean air" function is activated. This function switches the appliance on for ten minutes every hour at the first speed. As soon as this function is activated the motor starts up at the first speed for ten minutes, During this time key F and key C must flash at the same time. After ten minutes the motor switches off and the LED of key F remains switched on with a fixed light until the motor starts up again at the first speed after fifty minutes and keys F and C start to flash again for ten minutes and so on. [. . . ]