User manual BEKO CTB 9250 XH

[. . . ] Do not dispose of the packaging materials together with the domestic or other wastes. Take them to the packaging material collection points designated by the local authorities. This product was manufactured using the latest technology in environmentally friendly conditions. The Instructions for Use apply to several versions of this appliance. [. . . ] Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. The hood should not be used by children or persons not instructed in its correct use. Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. Clean and/or replace the Filters after the specified time period (Fire hazard). Clean the hood using a damp cloth and a neutral liquid detergent. Motor power Lamp power Air outlet pipe diameter Net weight Gross weight Color Markings on the product or the values stated in other documents supplied with the product are values obtained under laboratory conditions as per relevant standards. These values may vary according to the usage of the product and ambient conditions. 1 Drilling the Support surface and Fitting the Hood screw Fitting · The hood support surface must be 135 mm Above the bottom surface of the wall units. Drill the support with a ø 4, 5 mm drill bit, using Cut a hole ø 120-150 mm in size on the sup- Fix using the 4 screws 12a (4, 2 x 44, 4) provided. The hood can be installed either directly on the Bottom surface of the wall units using snap-on side supports. Cut a fitted opening in the bottom surface of the wall unit, as shown. Insert the hood until the side supports snap into place. Lock in position by tightening the screws Vf from underneath the hood. The space between the edge of the hood and the rear wall can be closed by applying the element 20 provided, using the screws supplied for this purpose. Cut a hole ø 125 mm in any shelf that may be positioned over the hood. Insert the reducer flange 9 on the hood body outlet. Connect the flange to the outlet on the shelf over the hood by using a flexible or rigid pipe ø120 mm. Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the air outlet grid 8 on the recirculation air outlet by using the 2 screws 12e (2, 9 x 9, 5) provided. Ensure that the activated charcoal filters have been inserted. When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. Insert the reducer flange 9 on the hood body outlet. [. . . ] When refitting the filters, make sure that the handle is visible on the outside. A Warning: Turn the lights off and wait until the lamps cool down before you change the odour filter. These filters are not washable and cannot be regenerated, and must be replaced approximately every four months or more frequently by particularly heavy use. Fit the new filter by hooking it into its seating. [. . . ]