User manual BEKO D532

[. . . ] Safety first /1 Electrical requirements /2 Transportation instructions /2 Installation instructions /2 Getting to know your appliance /3 Suggested arrangement of food in the appliance /3 Temperature control and adjustment /3 Before operating /4 Storing frozen food /4 Freezing fresh food /4 Making ice cubes /4 Defrosting /5 Replacing the interior light bulb /5 Cleaning and care /5 Repositioning the door /6 Do's and don'ts /6 Information about operating noises /7 Trouble ­ shooting /8 Thechnical data /8 Congratulations on your choice of a Quality Appliance, designed to give you many years of service. Do not connect your appliance to the electricity supply until all packing and transit protectors have been removed. ⷠLeave to stand for at least 4 hours before switching on, to allow compressor oil to settle, if transported horizontally. ⷠIf you are discarding an old appliance with a lock or latch fitted to the door, ensure that it is left in a safe condition to prevent the entrapment of children. [. . . ] Do not allow to come into contact with cooked food, to avoid contamination. For safety, only store raw meat for two to three days. 6 , max , max being the coldest position. When the appliance is switched on for the first time, the setting knob should be adjusted so that after 24 hours, the average fridge temperature is no higher than +5° (+41° C F). We recommend you set the knob half way between the min and max setting and monitor to obtain the desired temperature i. Towards max you will obtain a colder fridge temperature and vice versa. Some sections of the fridge may be cooler or warmer (such as the salad crisper and the top part of the cabinet) which is quite normal. the normal storage temperature of the freezer should be -18° (0° Lower temperatures C F). May be obtained by adjusting setting knob towards max position. We recommend that you check the temperature with an accurate thermometer to ensure that the storage compartments are kept to the desired temperature. Remember you must take your reading very quickly since the thermometer temperature will rise very rapidly after you remove it from the freezer. You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also make some (noise), whether the compressor is running or not. Slight undulation of the top of the cabinet is quite normal due to the manufacturing process used; it is not a defect. Fill the ice - cube tray 3/4 full with water and place it in the freezer. Loosen frozen trays with a spoon handle or a similar implement; never use sharp-edged objects such as knives or forks. The defrost water runs to the drain tube via a collection container at the back of the appliance (Item 6). During defrosting, water droplets may form at the back of the fridge compartment where a concealed evaporator is located. Some droplets may remain on the liner and refreeze when defrosting is completed. Do not use pointed or sharp-edged objects such as knives or forks to remove the droplets which have refrozen. If, at any time, the defrost water does not drain from the collection channel, check that no food particles have blocked the drain tube. The drain tube can be cleared with a pipecleaner or similar implement. [. . . ] If you want to remove the tray to clean it, follow the instructions below: · Switch off at the socket outlet and pull out the mains plug · Gently uncrimp the stud on the compressor, using a pair of pliers, so that the tray can be removed · Clean and wipe it dry · reassemble , reversing the sequence and operations 13. Don't- Exceed the maximum freezing loads when freezing fresh food. Don't- Give children ice-cream and water ices direct from the freezer. The low temperature may cause 'freezer burns' on lips. [. . . ]