User manual BEKO DG5822

[. . . ] ⷠDo not connect your appliance to the power supply until all packing and transit protectors have been removed. ⷠLeave to stand upright for at least 4 hours before switching on to allow the system to settle if transported horizontally. ⷠThis appliance must only be used for its intended purpose, i. We do not recommend use of this appliance in an unheated, cold room e. [. . . ] ⷠThe electrical safety of the appliance is only assured when the grounding system in the house is installed in accordance with regulations. ⷠWhen placing the appliance, do not let the power cable get stuck under it; otherwise the cable will be damaged. The electrical specifications of your appliance is given on the rating label located inside the appliance. ⷠRoute power cable to allow easy connection and disconnection after installation. ⷠA contact separator should be used if the power cable is not accessible. Do not operate your appliance in a room where the temperature is likely to fall below 10 °C at night and/or especially in winter. At lower temperatures the appliance may not operate, resulting in a reduction in the storage life of the food. ⷠThe climate class rate of your appliance is given on the rating label located inside the appliance. Get to know your appliance Prior to startup Warning Below information about accessories are supplied only for reference. Below accessories may not be exactly same as the accessories of your appliance. Air grill Before you start operating your appliance, the following points should be re-checked for safety: · Is there sufficient space for good air circulation?Be careful to prevent water from getting into contact with the electrical connections of the temperature control or the interior light. If the appliance is not going to be used for a long period of time, unplug the power cable remove all food. Clean the appliance and keep the door open. To preserve the appearance of your appliance, you can polish the exterior and the door accessories with a silicone wax. inspect the door gasket at regular intervals. Clean with water only, and wipe totally dry. Should the light fail to work, proceed as follows. 1- Switch off the circuit breaker or unplug the power cable. You may find it useful to remove shelves for easy access. If the bulb works, replace the light cover by inserting the rear lug and pushing up to locate the front two lugs. 4- If the light still fails to work, switch off the circuit breaker or unplug the power cable. [. . . ] ⷠRefer to the shelf life indicated on the food packaging. ⷠDo not obstruct the air circulation inside the appliance by covering the shelves. ⷠNever keep any dangerous or poisonous substances inside your appliance. ⷠAlways check food that has been stored for a long period of time for its suitability for consumption. [. . . ]